Berner BSD-HD-1 Manual Original página 12

Technical data
English
Screwdriver
Article number
Rated power input
Max. power output
No-load speed
Rated speed
Tool holder
Max. screw diameter
Weight according to
EPTA-Procedure 01:2014
Protection class
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-
specific models.
Noise/Vibration Information
Noise emission values determined according to EN 62841-2-2.
Typically, the A-weighted noise level of the power tool is:
Sound pressure level
Sound power level
Uncertainty K
Wear hearing protection
Vibration total values a (triax vector sum) and uncertainty K determined according to EN 62841-2-2:
h
Screwdriving:
a
h
K
The vibration level and noise emission value given
in these instructions have been measured in ac-
cordance with a standardised measuring proced-
ure and may be used to compare power tools.
They may also be used for a preliminary estima-
tion of vibration and noise emissions.
The stated vibration level and noise emission
value represent the main applications of the
power tool. However, if the power tool is used for
other applications, with different application tools
or is poorly maintained, the vibration level and
noise emission value may differ. This may signific-
antly increase the vibration and noise emissions
over the total working period.
To estimate vibration and noise emissions accur-
ately, the times when the tool is switched off or
when it is running but not actually being used
should also be taken into account. This may signi-
ficantly reduce vibration and noise emissions over
the total working period.
Implement additional safety measures to protect
the operator from the effects of vibration, such as
servicing the power tool and application tools,
12 | English
W
W
min -1
min -1
¼" internal hexagon
mm
kg
English
dB(A)
dB(A)
dB
2
m/s
m/s 2
keeping their hands warm, and organising work-
flows correctly.
Assembly
Pull the plug out of the socket before carry-
u
ing out any work on the power tool.
Changing the Tool (see figure A)
Pull the depth stop (4) off towards you. Pull the
screwdriver bit (1) out. If required, the universal
bit holder (10) can also be pulled out and re-
placed.
After changing the tool, reattach the depth stop .
Operation
Starting Operation
Pay attention to the mains voltage. The
u
voltage of the power source must match the
BSD-HD-1
040745
701
327
0–2500
0–1700
¼" internal hexagon
6
1.5
/ II
BSD-HD-1
81
92
3
< 2.5
1.5
English
English
English
1 609 92A 53N • 15.4.19
BSD-S-1
040749
701
327
0–4500
0–3000
6
1.4
/ II
BSD-S-1
79
90
3
< 2.5
1.5
English