brondell SWASH DR802 Manual Del Usuario página 22

OPERATING THE SWASH
Special Mode Operations
Activating / Deactivating Nightlight
The Nightlight is activated at the factory
by default.
1. To deactivate the Nightlight, touch and hold
"+" for four seconds.
This function cannot be performed while
sitting on the seat.
2. To activate the Nightlight, touch and hold
"+" for four seconds.
This function cannot be performed while
sitting on the seat.
Automatic Deodorizer
Your new Swash comes with an Automatic
Deodorizer, which turns on when the Seat
Sensor is engaged. The deodorizer will
continue to run for one minute after the seat
has been vacated.
To deactivate the automatic deodorizer,
press and hold the Eco Mode button for four
seconds while not seated on the Swash.
Sleep Mode
In Sleep Mode, the Swash essentially powers
down. The Nightlight, the seat heater and the
water heater will turn off.
1. To activate Sleep Mode, touch and hold
Stop button on the Auxiliary Control for four
seconds. The unit will power down.
2. To awaken the Swash from Sleep Mode,
touch the Stop, Front, or Strong button on
the Auxiliary Control.
20
Factory Default Reset
It is possible to reset the Swash to Factory
Default settings.
To reset the Factory Default settings, touch and
hold the Stop button on the Auxiliary Control
for ten seconds. A beep will sound at two
seconds indicating the beginning of the reset
process and another beep will sound at four
seconds indicating the reset is activated.
Resetting the seat to Factory Default does
not change personalized programming on the
remote control. To reset the remote control
to Factory Default settings, open the battery
compartment and remove the batteries.
Replace after 1 minute.
Automatic Tank Draining
1. To prevent stagnation, water in the warm
water storage tank can be set to drain and
refill itself if the seat hasn't been used in 48
hours.
2. To program this feature, touch Stop and
Water Temp at the same time and hold for
four seconds.