brondell SWASH DR802 Manual Del Usuario página 17

OPERATING THE SWASH
DR802 Remote Control
1. Stop
Stops all wash and dry functions
currently operating.
2. Rear Wash / Move
Touch once to initiate a rear wash. Touch
again to initiate nozzle oscillation (repetitive
forward and backward nozzle movement).
3. Front Wash / Move
Touch once to initiate a front wash. Touch
again to initiate nozzle oscillation (repetitive
forward and backward nozzle movement).
4. Strong Wash / Move
Touch once to initiate a strong wash. Touch
again to initiate nozzle oscillation (repetitive
forward and backward nozzle movement).
5. Dry
Touch once to initiate a two-minute Warm Air
Dryer cycle.
6. Nozzle Position
Touch the up and down arrows to adjust
the nozzle position forward and backward
during a wash cycle.
7. Water Temperature and Indicator
Touch and release Water Temp to adjust the
outgoing water temperature to one of four
settings (Low: 91.4°F, Medium: 96.8°F, High:
102.2°F, and Off). Settings will be saved for
the next use.
8. Seat Temperature and Indicator
Touch and release Seat Temp to adjust the
seat temperature to one of four settings
(Low: 93.2°F, Medium: 100.4°F,
High: 107.6°F, and Off). Settings will be
saved for the next use.
9. Pulse
Touching Pulse while a wash is
running enables the water to repeatedly
increase and decrease in pressure in a
pulsating pattern.
10. Gentle Mode Button
Touch Gentle to initiate a two-minute
gentle wash cycle followed by a two-minute
dry cycle. See page 17 for more information.
11. Water Pressure and Dry Temperature
and Indicators
Touch "+" and "–" to increase and decrease
the outgoing water pressure to one of five
settings. Touching these while the Warm
Air Dryer is operating will adjust the drying
temperature. For Front Wash, Rear Wash
and Dry, settings will be saved for next
use. For Strong Wash, the highest pressure
settings will default for all uses.
12. Nozzle Cleaning
Touch Nozzle Cleaning to initiate Nozzle
Cleaning when not sitting on the seat, or
while seat sensor is deactivated. For more
nozzle maintenance see page 22.
13. Eco Mode and Indicator
Touch and release Eco Mode to select
between two energy-saving options
(Standard, High-Efficiency). See page 18 for
more information.
14. User Memory 1
User Memory 1 contains the programming
for all of the custom settings to User 1's
wash cycles. See page 19 for more details.
15. User Memory 2
User Memory 2 contains the programming
for all of the custom settings to User 2's
wash cycles. See page 19 for more details.
16. Remote Control IR Signal Sensor
Transmits the signal from remote control to
the seat when a button is touched.
15