Troubleshooting - GYS NOMAD POWER PRO 90 Manual Del Usuario

BATTERY SWITCHING FUNCTION (OBD CABLE NOT SUPPLIED, REF. 054202)
Before each use, please check that all the vehicle's systems are off (lights, ventilation, onboard computer) :
1- Check that the product's internal battery is charged (see p.8)
2- Connect the cable with the OBD connector (not supplied, ref. 054202) to the vehicle and connect the other end to the cigarette lighter socket on the NOMAD
POWER (6).
3- Press the "ON/OFF" button, all the LEDs will light up succesively and the NOMAD POWER PRO will start to supply power to the vehicle's systems.
4- Disconnect the vehicle's battery and put the terminals on a non conducting element.
5- Once the battery is reconnected to the vehicle, disconnect the OBD plug.
6- Recharge the product after each use.
12V POWER SUPPLY - THROUGH THE CIGARETTE LIGHTER SOCKET (CABLE NOT SUPPLIED)
This product can sustain a 12V power supply through the cigarette lighter socket:
1- Check that the product's internal battery is charged (see p.8)
2- Check that the equipment you wish to connect to the NOMAD POWER is off then connect the cigarette lighter plug (not supplied) between the NOMAD POWER
and the equipment.
3- Press the "ON/OFF" button, all the LEDs will light up succesively and the NOMAD POWER PRO will start to supply power to your equipment
4- Swith off the equipment once you are done and disconnect the cigarette lighter plug (not supplied) from the NOMAD POWER.
6- Recharge the product after each use.
FLASHLIGHT FUNCTION
PROTECTIONS
This device is protected against short-circuits, polarity reversals and use under non-recommended temperatures (reminder: optimum working condition -20°C / +40
°C).
TROUBLESHOOTING, CAUSES, REMEDIES

TROUBLESHOOTING

No response while pressing the ON/
1
OFF button
2 Impossible to start the vehicule.
10
NOMAD POWER PRO 90
When power is on, press the button
Briefly press the button
OFF).
CAUSES
The NOMAD POWER PRO is discharged.
Vehicle battery level is too low.
Vehicle battery is out of order.
"Engine size is too big
- Petrol engine : 6000 cm3 max
- Diesel engine : 3500 cm3 max"
Short-circuit
to turn on the LED.
to switch lighting modes (4 available modes: normal, flash, SOS and
Charge the product (see page 8).
Force the start (see step 6b).
Change the vehicle battery
-
Check that the clamps are connected properly (see step 4).
EN
REMEDIES