Dremel 2050 Instrucciones De Funcionamiento página 20

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

2610Z09741 12-17 2050.qxp_2050 12/19/17 10:39 AM Page 20
EZ Lock™ Mandrel No. EZ402 has a
spring-loaded sleeve and is used with
sanding disks, abrasive buffs and polishing
cloth.
disconnect the plug from the power
source or the battery pack from the tool
before changing accessories. Such
preventative safety measures reduce the risk
of starting the power tool accidentally.
To load accessory:
1. Insert EZ Lock™ mandrel 1 into collet as
deep as possible and tighten Dremel collet
nut (Fig. A1).
Note: There is a blue spacer 2 that will
bottom out on the collet nut, setting the
mandrel to the correct depth.
2. Pull spring-loaded sleeve 3 DOWN
towards tool with one hand and hold. You
can brace the tool on the body or
workbench for extra leverage (Fig. A2).
3. With the other hand, align bow tie interface
4 on mandrel with metal bow tie interface 5
on bottom of accessory 6 (Fig. A2).
4. Place accessory on the mandrel to a point
just below the bow tie on the mandrel 4
and twist 90 degrees until the bow tie
interface 5 on the accessory 6 aligns with
the sleeve 3. Release sleeve 3. Accessory
6 should lock in place (Fig. A3).
may lead to personal injury or property
damage. To check for proper seating, hold
shaft lock button 7 and twist the accessory 6.
The accessory 6 will not be able to rotate on
mandrel.
To unload accessory:
1. Pull spring-loaded sleeve 3 DOWN toward
tool with one hand (Fig. A3).
2. Hold sleeve 3 down while twisting
accessory 6 90 degrees (Fig. A3).
3. Remove accessory 6 (Fig. A3).
During use
Avoid damage to EZ lock™ mandrel by not
letting it contact the workpiece.
20
EZ Lock
Operating Instructions
Always make sure the
rotary tool is "OFF" and
Incorrect seating of
accessory on mandrel
FIG. A1
FIG. A2
5
4
3
90°
5
3
2
1
7
6
FIG. A3
6
4
Tabla de contenido
loading

Tabla de contenido