Gorenje DVG 6640 W Instalación, Mantenimiento Y Uso página 24

Operation
Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched
on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating
cooking.
Control
Sensor ''Slider''- adjust the fan speed level, ranging from 1 to 9,
Sensor ''On / Off''(I / 0)
- turns on and off the fan
turns on the fan, on last memorized fan speed,
longer touch "on / off" sensor, when the fan is turned on, 5 min. timer is on (informing - a dot on the display).
Sensor ''Light''(L)
turns on / off lighting
longer touch causes a gradual brightening / dimming of lighting, on 3 levels of 100, 75 and 50%
Should the control panel get locked, disconnect the hood from the power supply outlet and reconnect it after 5 minutes. After this time,
the control panel will resume normal operation
Maintenance
ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the
connector and removing the connector fuse.
Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket.
Cleaning
The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the fat filters)
internally and externally. Clean using the cloth dampened with neutral liquid detergent. Do not use abrasive products. DO NOT USE
ALCOHOL!
WARNING: Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the filters may cause fire
risks.
Therefore, we recommend observing these instructions.
The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or
failure to observe the above safety recommendations.
Grease filter
Traps cooking grease particles.
This must be cleaned once a month (or when the filter saturation indication system – if envisaged on the model in possession –
indicates this necessity) using non aggressive detergents, either by hand or in the dishwasher, which must be set to a low
temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle.
Replacing lamps
Disconnect the hood from the electricity.
Warning! Prior to touching the light bulbs ensure they are cooled down.
1. Using a flat head screwdriver or equivalent tool, carefully pry loose the light cover.
2. Remove the damaged light and replace with a new 12
Volt, 20 Watt (Maximum) halogen light made for a G-4 base SUITABLE FOR USE IN OPEN LUMINAIRES. Follow package
directions and do not touch new light with bare hands.
3. Reinstall the light cover. (it will snap shut).
If the lights do not work, make sure that the lamps are fitted properly into their housings before you call for technical assistance.
29