Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Blow Tube Assembly (Fig. B)
WARNING:
tube securely in place. Never reach down into housing
through tube hole.
WARNING:
you leave blower unattended or when storing, checking,
adjusting, cleaning, or working on blower.
1. To attach the blower tube
peg
9
of the power head with the notch
tube opening as shown in Fig. B.
2. Push the blower tube onto the power head until the tube
locks engage the blower tube and an audible click is heard.
3. Pull on the tube to ensure it is securely in place.
4. To remove the tube, insert a screwdriver into the unlocking
hole
10
on the side of the blower tube. Depress the tab
inside and pull tube off.
Concentrator Assembly (Fig. C)
Use the concentrator
7
attachment to target air flow to a
tighter area.
1. Align the concentrator
in Fig. C.
2. Slide the concentrator
3. Push down until the tabs
tube engage the locking holes
concentrator
7
.
4. Pull on the concentrator
5. To remove the concentrator
pull the concentrator
7
Inserting and Removing the Battery Pack
from the Tool (Fig. D)
WARNING:
battery, make certain the speed lock lever
position to prevent switch actuation.
nOTE: Make sure your battery pack
To Install the Battery Pack into the Tool Handle
1. Align the battery pack
5
handle (Fig. D).
2. Slide it into the handle until the battery pack is firmly seated
in the tool and ensure that you hear the lock snap into place.
To Remove the Battery Pack from the Tool
1. Press the release button
out of the tool handle.
2. Insert battery pack into the charger as described in the
charger section of this manual.
Do not operate blower without
Always remove the battery when
4
to the power head, align the
8
of the blower
7
with the tube assembly as shown
7
onto the tube
4
.
11
on both sides of the
12
in both sides of the
7
to ensure it is securely in place.
7
, depress the tabs
11
away from the tube.
Before removing or installing
2
is in the off
5
is fully charged.
with the rails inside the tool's
6
and firmly pull the battery pack
Fuel Gauge Battery Packs (Fig. D)
Some D
WALT battery packs include a fuel gauge which consists
e
of three green LED lights that indicate the level of charge
remaining in the battery pack.
To actuate the fuel gauge, press and hold the fuel gauge
button
13
. A combination of the three green LED lights will
illuminate designating the level of charge left. When the level of
charge in the battery is below the usable limit, the fuel gauge
will not illuminate and the battery will need to be recharged.
nOTE: The fuel gauge is only an indication of the charge left on
the battery pack. It does not indicate tool functionality and is
subject to variation based on product components, temperature
and end-user application.
OPERATION
Instructions for Use
WARNING:
instructions and applicable regulations.
WARNING:
personal injury, turn tool off and disconnect battery
pack before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.
WARNING:
tube securely in place. Never reach down into housing
and
through tube hole.
WARNING:
the locked position and remove the battery when:
-
-
Proper Hand Position (Fig. A, E)
WARNING:
personal injury, ALWAYS use proper hand position
as shown.
WARNING:
personal injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main handle
Always observe the safety
To reduce the risk of serious
Do not operate blower without
Always slide the lock-off switch to
You leave blower unattended.
Checking, adjusting, cleaning, or working
on blower.
To reduce the risk of serious
To reduce the risk of serious
EngLIsh
3
.
29
Tabla de contenido
