FLORABEST FLS 3000 B3 Traducción Del Manual De Instrucciones Original página 30

G B I E
tion of faults, read the "Trouble-
shooting" chapter or contact our
Service-Centre.
• Walk at a steady pace, do not run.
• Make sure that the mains volt-
age is compatible with the infor-
mation of the label.
• Keep the cable away from the
field of action and basically
play it out behind the operator.
• Do not carry the device by the
cable. Do not use the cable to
pull out the plug from the plug
socket. Protect the cable against
heat, oil and sharp edges.
• Damaged cables, coupling and
plugs or connecting leads not
corresponding to specifications,
must not be employed. Remove
the plug immediately from the
plug socket in case of damage
to the mains cable. Do not touch
the mains power supply cable
under any circumstances until
you have pulled the plug out of
the mains socket.
• Extension cords are to be kept
away from moving, dangerous
parts to prevent damages on
cables that can lead to contact-
ing of active parts.
Maintenance and storage:
• Check the operational service-
ability and integrity of the de-
vice regularly in order to avoid
danger to the operator.
• Only use the replacement parts
that are supplied and recom-
mended by our Service Centre.
• Do not attempt to repair the
appliance yourself unless you
have specific training to do so.
3 0
Leave any work not listed in this
manual to our Service Centre.
• Keep the device in a dry loca-
tion and out of reach of children.
• Handle the unit with care. Clean
the ventilation slits regularly; keep
to the maintenance instructions.
• Keep all cooling air inlets clear
of dirt.
• If the power cable for this equip-
ment is damaged, it must be
replaced by the manufacturer,
a customer service agent of the
same or a similarly qualified per-
son in order to prevent hazards.
• Do not use the appliance if the on/
off switch does not work properly.
Always have a damaged switch
repaired by our Service Centre.
• Do not overload your device.
Work only within the indicated
range of performance. Do not
employ any low power ma-
chines for heavy work. Do not
use your device for purposes for
which it has not been designed.
Additional safety instructions:
• After they have been joined to-
gether, the blower tubes cannot
be taken apart again!
• Switch off the device before
installing or removing the collec-
tion bag.
Recommendation:
• Connect the device, as far as
possible, only to a plug socket
with a ground-fault circuit inter-
rupter (g.f.c.i switch), with a rat-
ed residual current at not more
than 30 mA.