Residual Risks; Initial Start-Up; Assembling/Dismantling The Two-Piece Blow Tube - FLORABEST FLS 3000 B3 Traducción Del Manual De Instrucciones Original

• Avoid operating the machine in
poor weather conditions, especially
when there is a lightning hazard.

RESIDUAL RISKS

Even if properly operating and
handling this electric tool, some resi-
dual risks will remain. Due to its con-
struction and build, this electric tool
may present the following hazards:
a) Ear damage if working without
ear protection.
b) Damage to your health caused
by swinging your hands and
arms when operating the appli-
ance for longer periods of time
or if the unit is not held or main-
tained properly.
c) Lung damage, if suitable respira-
tory protection is not worn.
d) Eye injuries if no suitable eye
protection is worn.
Warning! During operation,
this electric tool generates an
electromagnetic field which,
under certain circumstances,
may impair the functionality
of active or passive medical
implants. To reduce the risk of
serious or lethal injuries, we
recommend that persons with
medical implants consult their
doctor and the manufacturer
of their medical implant befo-
re operating the machine.

Initial start-up

Before operating the equipment, you must
- install the blower or suction pipes,
- install the collection bag for suctioning
leaves,
- install the protective cover (suction intake)
for blowing leaves.
Caution, Risk of Injury! Du-
ring the assembly or disas-
sembly of the blower pipe,
suction pipe, protective cover
or collection bag, the engi-
ne must be turned off and
all moving parts must have
come to a standstill.
Always disconnect the plug
from the mains socket before
working.
Assembling/dismantling the
two-piece blow tube
Never use the leaf blower
with only one blower tube
section attached. There is a
risk of personal injury!
1. Assemble the two-piece blow
tube (9) as illustrated. The parts
can be felt to lock into place.
When putting it together, make
sure that the symbols (
upper and lower blower pipe
interlock.
2. Now push the blow tube (9) on
to the blowing aperture of the
motor housing (1) as far as the
locking device (8).
3. Place the protective cover of
the suction opening (7) on the
underside of the motor housing.
Turn the protective cover clock-
wise as far as it will go.
4. Attach the protective cover by ti-
ghtening the screw with star grip
(18) in the holder.
G B I E
) at the
3 1