Usage; Switching On The Maremed; Selecting The Fan Speed - Beurer maremed MK 500 Instrucciones De Uso

7. Usage

7.1 Switching on the maremed

1. Ensure that you have installed the water filter and pre-filter and filled the tank with tap wa-
ter and the maremed
2. Insert the mains plug into the socket. Ensure that the cable does not pose a trip hazard.
®
The maremed is now ready for use.
3. To switch on the maremed
the symbols on the touch display will briefly light up. The UVC lamp inside the device will
begin to light up.
CL
4. The letters will appear on the touch display. The FAN button
for 3 minutes. The water in the water tank will now be sterilised before the fan draws in the
air, ensuring that there is no bacterial contamination in the water.
5. After 3 minutes, the FAN button
matically. The maremed
Note
For safety reasons, if you remove the cover from the maremed
the mains, both the fan and the UVC lamp will automatically switch off. Once you put the
cover back on again, the 3-minute sterilisation process will start again. The fan won't start
again until this has finished.
Note
A slight odour initially develops after switching on the device for the first time. This is nor-
mal and not harmful to your health. Allow the device to run for three to five minutes. After
that you can use the device as normal.

7.2 Selecting the fan speed

The maremed comes with a total of 3 fan speeds.
®
• Select your desired fan speed using the FAN button
currently set is shown on the touch display.
®
®
special sea salt.
® , press and hold the ON/OFF button
will light up permanently. The fan will now start auto-
® will now run continuously.
681.19_MK500_2019-05-28_01_Display_BEU
®
681.19_MK500_2019-05-28_01_Display_BEU
. The fan speed
32
for 3 seconds. All of
will now start to flash
when it is connected to
that is