Repairing; Troubleshooting - Stihl FSA 130 R Manual De Instrucciones

17 Repairing

16.3 Sharpening and Balancing a
Metal Cutting Attachment
Correctly sharpening and balancing metal cutting
attachments requires a lot of practice.
STIHL recommends you have metal cutting
attachments resharpened and balanced by a
STIHL servicing dealer.
► Sharpen the metal cutting attachment as
described in the instructions and on the pack‐

18 Troubleshooting

18.1 Troubleshooting the Brushcutter and Battery
Fault LEDs on the
battery
The brushcutter 1 LED flashing
does not start green.
when switched
on.
1 LED emits
red light.
3 LEDs flash
red.
3 LEDs light
up red.
4 LEDs fla‐
shing red.
The brushcutter 3 LEDs light
cuts out during up red.
operation.
0458-725-9821-D
aging supplied with the cutting attachment you
are using.
17 Repairing
17.1
The trimmer and cutting attachment cannot be
repaired by the user.
► If the trimmer or cutting attachment is dam‐
aged: Do not use your trimmer or cutting
attachment and contact your STIHL servicing
dealer.
Cause
State of charge of the
battery is too low.
The battery is too
warm or too cold.
The brushcutter has a
malfunction.
The brushcutter is too
hot.
There is a fault in the
battery.
No electrical contact
between brushcutter
and battery.
The brushcutter or
battery is damp.
The brushcutter is too
hot.
There is an electrical
fault.
Repairing the Trimmer and
Cutting Attachment
Remedy
► Recharge the battery fully as described
in the User Manual for the STIHL AL
101, 300, 500 chargers.
► Pull the connecting cable plug out of the
socket.
► Allow the battery to cool down or warm
up.
► Pull connecting cable plug out of the
socket and plug in again.
► Switch on the brushcutter.
► If 3 LEDs continue to flash red: Do not
use your brushcutter and contact your
STIHL dealer for assistance.
► Pull the connecting cable plug out of the
socket.
► Allow the brushcutter to cool down.
► Pull connecting cable plug out of the
socket and plug in again.
► Switch on the brushcutter.
► If 4 LEDs continue to flash red: Do not
use the battery and contact your STIHL
dealer for assistance.
► Pull connecting cable plug out of the
socket and plug in again.
► If the brushcutter still does not start
when switched on: Clean the contacts of
the connecting cable as described in the
STIHL AR battery's user manual or in
the user manual for the "AP belt bag with
connecting cable".
► Allow the brushcutter or battery to dry.
► Pull the connecting cable plug out of the
socket.
► Allow the brushcutter to cool down.
► Pull connecting cable plug out of the
socket and plug in again.
English
41