After Finishing Work; Transporting; Storing; Cleaning - Stihl FSA 130 R Manual De Instrucciones

English
11.4.2 Line Feed on SuperCut Mowing Head
Mowing lines are advanced automatically. The
line limiting blade in the deflector trims the mow‐
ing lines to the correct length.
Automatic feed will not take place if the mowing
lines are shorter than 40 mm.
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
► Pull out the mowing lines.
► If the mowing lines cannot be pulled out to
required length: Replace nylon line.
The spool is empty.

12 After Finishing Work

12.1 When Work is Finished
► Switch off the brushcutter and pull the con‐
necting cable plug out of the socket.
► If the brushcutter is wet: Allow the brushcutter
to dry.
► Clean the brushcutter.
► Clean the deflector.
► Clean the cutting attachment.
► If a metal cutting attachment is mounted: Fit
the matching transport guard.

13 Transporting

13.1 Transporting the brushcutter
► Switch off the brushcutter and pull the con‐
necting cable plug out of the socket.
► If a metal cutting attachment is mounted: Fit
the matching transport guard.
Carrying the brushcutter
► Carry the brushcutter in one hand properly
balanced by the shaft, with the cutting attach‐
ment behind you.
Transporting the brushcutter in the car
► Secure the brushcutter to prevent turnover
and movement.

14 Storing

14.1 Storing the Brushcutter
► Switch off the brushcutter and pull the con‐
necting cable plug out of the socket.
► If a metal cutting attachment is mounted: Fit
the matching transport guard.
► Ensure that the following conditions are met
when storing the brushcutter:
– The brushcutter is out of the reach of chil‐
dren.
– The brushcutter is clean and dry.
40
► If you store the brushcutter for more than 3
months: Remove the cutting attachment.

15 Cleaning

15.1 Cleaning the Brushcutter
► Switch off the brushcutter and pull the con‐
necting cable plug out of the socket.
► Clean the brushcutter with a damp cloth.
► Clean vents with a paintbrush.
15.2 Cleaning the Deflector and Cut‐
ting Attachment
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
► Clean the deflector and cutting attachment
with a damp cloth or a soft brush.

16 Maintenance

16.1 Maintenance Intervals
The maintenance intervals are dependent on the
environmental and operating conditions. STIHL
recommends the following maintenance inter‐
vals:
After every 50 hours of operation
► Lubricate the gearbox.
Every 12 months
► Have the trimmer checked by a STIHL servic‐
ing dealer.
16.2 Lubricating the Gearbox
1
► Remove the screw plug (2).
► If no grease can be seen on the end of the
screw plug (2):
► Screw the tube (1) of STIHL gear grease
into the filler hole.
► Squeeze 5 g of STIHL gear grease into the
gear housing.
► Unscrew the tube (1) of STIHL gear grease.
► Refit and tighten down the screw plug (2)
firmly.
► Run the trimmer for 1 minute.
STIHL gear grease is distributed evenly.
12 After Finishing Work
2
0458-725-9821-D