Repairing; Troubleshooting - Stihl HSA 56 Manual De Instrucciones

16 Repairing

► Switch off the hedge trimmer, push retaining
latch to position and remove the battery.
► Use a STIHL flat file to sharpen each cutting
edge on the upper blade. The file only sharp‐
ens on the forward stroke. Maintain the pre‐
scribed sharpening angle,
► Turn the hedge trimmer over.
► Sharpen the remaining cutting edges.
► Deburr each cutting edge from below.
► Turn the hedge trimmer over.
► Deburr the remaining cutting edges.
► Use a damp cloth to remove the filing dust.
► Spray both sides of cutting blades with STIHL
resin solvent.

17 Troubleshooting

17.1 Troubleshooting Hedge Trimmer or Battery
Fault LEDs on the
battery
Hedge trimmer 1 LED flashing
does not start green.
when switched
on.
1 LED emits
red light.
3 LEDs flash
red.
3 LEDs light
up red.LEDs
light up red.
4 LEDs
flash red.
0458-714-9821-D
18.2.
Cause
State of charge of the
battery is too low.
The battery is too
warm or too cold.
There is a malfunction
in the hedge trimmer.
The cutting blades do
not run freely.
Hedge trimmer is too
hot.
There is a fault in the
battery.
► Run the hedge trimmer for 5 seconds.
The cutting blades run. STIHL resin solvent is
distributed evenly.
► If you have any doubts, be sure to consult a
STIHL dealer.
16 Repairing
16.1 Repairing Hedge Trimmer, Bat‐
tery and Charger
The hedge trimmer, cutting blades, battery and
charger are not user serviceable.
► If the hedge trimmer or cutting blades are
damaged: Do not use your hedge trimmer and
contact your STIHL servicing dealer.
► If the battery has a malfunction or is damaged:
Replace the battery.
► If the charger has a malfunction or is dam‐
aged: Replace the charger.
► If the connecting cable has a malfunction or is
damaged: Do not use the charger and have
connecting cable replaced by a STIHL servic‐
ing dealer.
Remedy
► Charge the battery.
► Remove the battery.
► Allow the battery to cool down or warm
up.
► Remove the battery.
► Clean electrical contacts in the battery
compartment.
► Insert battery.
► Switch on the hedge trimmer.
► If 3 LEDs continue to flash red: Do not
use your hedge trimmer and contact your
STIHL servicing dealer for assistance.
► Spray both sides of cutting blades with
STIHL resin solvent.
► If 3 LEDs continue to flash red: Do not
use your hedge trimmer and contact your
STIHL servicing dealer for assistance.
► Remove the battery.
► Allow the hedge trimmer to cool down.
► Remove battery and reinsert it.
► Switch on the hedge trimmer.
► If 4 LEDs continue to flash red: Do not
use the battery and contact your STIHL
dealer for assistance.
English
37