Tabla de contenido
Idiomas disponibles
Idiomas disponibles
iNSTallaTiON
appliance shutdown
f Activate the safety switch by firmly pressing the reset button
f
(the appliance is delivered with the safety switch disabled).
f Insert the plug of the programming unit connecting cable at
f
the PCB.
Note
It is essential to plug the connecting cable for the pro-
gramming unit into the PCB before switching on the
power. Otherwise, the programming unit will not func-
tion.
f Hook the appliance cover into the appliance back panel at the
f
top rear. Pivot the appliance cover downwards. Check that
the appliance cover is securely seated both top and bottom.
f Secure the appliance cover with the screw.
f
f Remove the protective film from the user interface.
f
f Switch on the power supply.
f
f Ensure that the programming unit is functioning correctly.
f
11.3.1 Appliance handover
f Explain the appliance function to users and familiarise them
f
with how it works.
f Make users aware of potential dangers, especially the risk of
f
scalding.
f Hand over the instructions.
f
www.stiebel-eltron.com
11.4 Recommissioning
Material losses
!
To ensure that the bare wire heating system is not dam-
aged following an interruption to the water supply, the
appliance must be recommissioned by taking the follow-
ing steps.
f Disconnect the appliance from the power supply by
f
removing the fuses/tripping the MCBs.
f Open the tap for at least one minute until the appli-
f
ance and its upstream cold water inlet line are free
of air.
f Switch on the power supply again.
f
12. Appliance shutdown
f Isolate all poles of the appliance from the power supply.
f
f Drain the appliance (see chapter "Maintenance / Draining the
f
appliance").
13. Installation alternatives
WARNING Electrocution
Before any work on the appliance, disconnect all poles
from the power supply.
13.1 Electrical connection from above on unfinished
walls
1 Cable grommet
2 Cable routing
f Break out the required aperture in the back panel for the
f
power cable (for positions, see chapter "Specification / Di-
mensions and connections"). Deburr any sharp edges with a
file.
f Cut a hole in the cable grommet to fit the selected connecting
f
cable. Fit the cable grommet.
f Reposition the mains terminal from the bottom to the top.
f
To do so, unclip the mains terminal by pushing it firmly to
the left and pulling it forwards. Turn the mains terminal with
connecting cables 180° clockwise. Lay the internal wiring
under the cable guide. Clip the mains terminal in by pushing
it inwards and to the left until it clicks into place.
f Install the appliance and connect the power cable to the
f
mains terminal as described in chapter "Installation / Stand-
ard installation on finished walls".
1
2
DCE-X Premium |
13
Capítulos
Tabla de contenido
Solución de problemas
