Nolan N70-2 X Seguridad E Instrucciones página 21

The silicone-sealed profile of the PINLOCK
the inner surface of the visor.
1.4 Insert one side of the PINLOCK
position (Fig.13).
1.5 Widen the visor and fasten the other side of the PINLOCK
pin (Fig.14).
1.6 Release the visor.
1.7 Remove the protective film from the PINLOCK
entire silicone-sealed profile of the inner visor adheres to the visor.
1.8 Fix the visor onto the helmet (see instructions above).
2 CHECKING AND ADJUSTING THE PINLOCK
Check the correct PINLOCK
and ensuring that they do not move with respect to each other.
Should the PINLOCK
both external adjustment levers upwards, to increase the stretch gradually and not
excessively (Fig.12).
The maximum stretch is achieved when the pin adjustment external levers are turned
outwards.
WARNING
- The presence of dust between the two visors may produce scratches on both
surfaces.
- Scratched PINLOCK
must therefore be replaced.
- Regularly check the correct stretch of the PINLOCK
moving and scratching both surfaces.
- If the helmet visor fogs up and/or condensation forms between the visors, check
that the PINLOCK
- An excessive and early stretch of the PINLOCK
sive adherence against the visor surface and/or permanent deformations with
subsequent inability to correctly perform any following adjustments.
- Intense sweating/breathing, the use under particular weather conditions (low tem-
peratures, high humidity, sudden changes in temperature or heavy rain) or intense
and prolonged use may affect the performance of the PINLOCK
cause fogging or formation of condensation. In such cases, to restore the sys-
tem efficiency after using the helmet, remove the PINLOCK
helmet visor and let it dry with dry and warm air. The same procedure must be
applied to the helmet, in order to dry out humidity in case it has formed up as a
consequence of the conditions described above.
3 DISASSEMBLING THE PINLOCK
3.1 Remove the visor equipped with the PINLOCK
above).
3.2 Widen the visor and release the PINLOCK
3.3 Release the visor.
inner visor into one of the visor pins and hold it in
®
inner visor assembly by opening and closing the visor
®
inner visor not be tightly fixed to the visor, simultaneously move
®
visors and inner visors may cause reduced visibility and
®
inner visor is both correctly assembled and stretched.
®
®
inner visor must be in contact with
®
inner visor and check that the
®
INNER VISOR STRETCH
®
®
inner visor may result in exces-
®
INNER VISOR
inner visor (see instructions
®
inner visor from the pins (Fig.14).
®
inner visor to the other
®
inner visor to prevent it from
inner visor and
®
inner visor from the
®
INSTRUCTIONS FOR USE
N70-2 X
21