Nolan N70-2 X Seguridad E Instrucciones página 19

the peak from a Nolangroup authorised dealer.
The peak can be adjusted in different positions by rotating it upwards or downwards
(Fig.5).
1 ADJUSTING THE PEAK
1.1 Loosen the tightness of the upper central threaded cover plate "A" by rotating it
counter-clockwise (Fig.6).
1.2 Rotate the peak around the side cover plates "B" to adjust it to the desired posi-
tion (Fig.5).
1.3 Lock the peak in the desired position by tightening the upper central threaded
cover plate "A" (Fig.6).
2 DISASSEMBLING THE PEAK
2.1 Release the bayonet side cover plates "B" by rotating them by 90° so that the
side ends of the peak are detached from the helmet shell (Fig.7). Be careful not to
lose the two trims positioned between the peak and the shell, which must remain
hooked to the cover plates (Fig.8).
2.2 Completely unscrew the upper central threaded cover plate "A" by rotating it
counter-clockwise (Fig.6). Remove the peak from the helmet, being careful not to
lose the trim of the upper central threaded cover plate "A" positioned between the
peak and the shell (Fig.9).
3 ASSEMBLING THE PEAK
Ensure that the side cover plates "B" and the corresponding internal trims are correctly
hooked to the peak as in the beginning (Fig.8).
3.1 Position the trim of the upper central cover plate "A" at the threaded hole (Fig.9)
and place the peak on the shell; then insert the upper central threaded cover plate
"A" into the hole and screw it by rotating it clockwise without tightening it com-
pletely (Fig.6).
3.2 Insert the left side cover plate "B" into the corresponding seat on the shell and lock
it by rotating it by 90°. Repeat the operation on the other side of the helmet (Fig.7).
3.3 Complete the adjustment of the peak position as instructed previously.
WARNING
- Ensure that the latches and their internal trims, which are interposed between the
peak and the shell of the helmet, keep the peak steady in the desired position.
- Do not use the helmet before assembling and adjusting the peak properly.
- Do not install the peak without the internal trims of the cover plates.
- The peak can be assembled over the visor or, in absence of the latter, over the side
plates.
- If the peak is assembled over the visor, check for proper functioning of the visor by
pulling it up and pulling it down completely.
- The peak comes with special internal spacers, suitable for reducing the risk of
damaging the visor during the last stage of its opening; do not remove these spac-
ers from the peak.
- In case of malfunctioning or damage, please contact an authorised Nolangroup
INSTRUCTIONS FOR USE
N70-2 X
19