Tabla de contenido
Safety
Signs, symbols and instructions placed on this product must never be covered or removed and must
remain present and clearly legible throughout the entire lifetime of the product. Immediately replace or
repair illegible or damaged signs, symbols and instructions. Contact your local dealer for instructions.
In case of an adverse event occurred in relation to the device, incidents should be reported to your local
dealer and the national competent authority in a timely manner. The local dealer will forward information
to manufacturer.
EN
Caregiver
• Read the "User Guide" carefully before use
and keep it for future reference. Incorrect
use of this product may cause serious injury
to the user
• This product contains small parts which
could present a choking hazard if removed
from their intended placing
• Always use the correct lifting techniques and
aids for this purpose
• Never leave the user unattended in this
product. Ensure permanent supervision by
an adult
• Be aware of any MAX mark indications
before adjustment
• Repair/replacements must only be made
using new original R82 spare parts and
fittings and carried out in accordance
with the guidelines and service intervals
prescribed by the supplier
• If there is any doubt as to the continued
safe use of your R82 product or if any
parts should fail, stop using the product
immediately and contact your local dealer
as soon as possible
• Always use the product in a moderate pace.
Do not run with the product
• Information about transportation can be
found in the document "Transportation in
Motor Vehicles" supplied with the product
• Information about roadability can be found
in the document "Roadability" supplied with
the product
• Information regarding frame and seat
combinations including max. load in
combination can be found at: support.r82.
org
Environment
• Observe the surface temperature on the
product, before placing an user in it. This
goes especially for users with insensitive
skin as they cannot feel the heat. If the
surface temperature is above 41°C then
allow the product to cool before use
• Use this product on a level surface without
any obstacles. Be aware of reduced
maneuverability on slippery surfaces
• When using on inclines, please refer to
measurements
User
• If the user is close to the max. load limit
and/or has a lot of involuntary movements,
e.g. rocking, a larger size with a higher max.
load or a different R82 product should be
considered
Product
• Carry out all positional adjustments on the
product and accessories and ensure that
all knobs, screws and buckles are securely
fastened before use. Keep all tools out of
the reach of children
• Activate the brakes before placing the user
into the product
• Activate the anti-tips when the product is
being used on inclines
• Activate the anti-tips before angling the seat
and back
• Deactivate the anti-tips when forcing kerbs
higher than 100 mm
• Ensure the stability of the product is
maintained before placing the user in it
• We recommend you notify the user before
angling the seat and back
• Ensure the wheels are fully-functional and
secure before use
• Do not expose the gas spring to pressure or
high temperatures. DO NOT puncture
• Do not expose the piston rod to scratches
etc. It is important to use a cloth or the like,
if tools are used to adjust the gas spring
• The user must not occupy the product
while it is being transported into or out of a
vehicle by a lift
• To achieve the required static stability the
Multi Frame:x with the Panda Future 5 seat
must be set in the most forwards position.
In other positions the static stability is not
sufficient. When setting the Multi Frame:x
with other seats or changing position,
please ensure that the seat and wheels are
in a stable position.
• Inspect the product and all of its accessories
and replace any worn out parts before use
30
support.R82.org
Tabla de contenido
