Installation - THERMEx ARLES Instrucciones De Montaje

M 513052068216062016

INSTALLATION

Arles is supplied with motor and the hood can either vent exhaust out into the open air or re-circulate the air. The hood must be installed in a wall
cabinet without a base.
Follow the steps in these instructions that match the type of hood you have chosen.
INSTALLATION OF THE NONE-RETURN VALVE
Mount the none-return valve on the hood before installing the hood:
1
Place the spring on one of the flaps for the
none-return valve.
INSTALLING THE HOOD
The hood is installed in the cabinet using the following steps:
1
Install the brackets for the securing of the
cabinet's back cover on the hood's spacer.
The bracket must be mounted with four
screws.
4
Mark the four holes on the sides of the
cabinet.
2
Mount the none-return valve in the flange on
the hood.
2
Remove the filters from the hood.
5
x4
Remove the hood from the cabinet again.
THERMEX ARLES
3
NOTE: Make sure that the spring is held in
place by the plastic pins.
3
Push the hood up into the cabinet.
6
Drill out the four holes using an 8 mm drill bit.
47
x4