GE PT925 El Manual Del Propietario página 27

WARNING
CAUTION
Socket
Receptacle
G6.35 Bulb
Tab
Glass cover
(on some models)
Socket
Receptacle
G9 Bulb
Tab
Glass cover
(on some models)
Wipe up heavy soil on the oven
bottom.
NOTE: Do not attempt to lift the
heating element. Doing so could
damage the element.
power to the oven at the main fuse or circuit breaker panel. Failure to do so may result
in electric shock or burn.
glass with bare hands or a damp cloth can cause burns.
Oven Light Replacement
To remove:
Turn the glass cover counterclockwise
1/4 turn until the tabs of the glass cover
clear the grooves of the socket. Wearing
latex gloves may offer a better grip.
Using gloves or a dry cloth, remove the
bulb by pulling it straight out.
To replace:
Use a new 120/130-volt halogen bulb,
not to exceed 50 watts. Replace the
bulb with the same type of bulb that
was removed. Your model will have one
of the two types shown on the left. To
determine the correct replacement bulb,
check the bulb terminals. Bulbs with 2
straight pin terminals are G6.35 bulbs.
Bulbs with 2 looped terminals are G9
bulbs. (Do not interchange.) Be sure the
replacement bulb is rated 120 volts or
130 volts (NOT 12 volts).
Using gloves or a dry cloth, remove the
bulb from its packaging. Do not touch the
bulb with bare fingers. Oil from skin will
damage the bulb and shorten its life.
Oven Heating Elements
Do not clean the heating elements. Any soil will
burn off when the elements are heated. Clean
the oven floor with warm, soapy water.
Before replacing oven light bulb, disconnect the electrical
(on some models)
GEAppliances.com
Receptacle
Push the bulb straight into the receptacle
all the way.
Place the tabs of the glass cover into
the grooves of the socket. Turn the glass
cover clockwise 1/4 turn.
For improved lighting inside the oven,
clean the glass cover frequently using a
wet cloth. This should be done when the
oven is completely cool.
Reconnect electrical power to the oven.
Use
gloves or
cloth
27