Tabla de contenido
Idiomas disponibles
Idiomas disponibles
- English -
Installation and connection
Turning the pump casing to achieve a different position
1. Remove the screws for fastening the
filter basket and remove the filter
basket.
2. Remove the screws for fastening the
stand and remove the stand
3. Remove the four screws for fastening
the retaining plate and remove the
retaining plate.
4. Remove the four screws and take off
the pump casing
5. Turn the pump casing, place it onto the
motor and fasten with the four screws.
6. Fit the retaining plate onto the pump
casing and fasten with the four screws
7. Fit the stand and filter basket in the
reverse order.
Connecting to Eco Control
As an option, Eco Control can be connected to the pump to control it.
• The control unit Eco Control is available as an accessory for Eco Expert pumps.
• If the pump is integrated in an EGC network, connecting Eco Control is not possible.
1. Remove the protection cap from
EGC-IN.
2. Fit the plug connector of the cable
and secure with the two screws
(max. 2.0 Nm) (max. 18 lb-in).
• Ensure that the rubber seal is
clean and fits exactly.
• Replace the rubber seal if
damaged.
Integrating the pump in the EGC network
The pump can be integrated in an EGC network. The InScenio EGC and all EGC compatible units are connected with each
other via Connection Cable EGC in an EGC network. A terminal resistor has to be fitted to the EGC-OUT of the last EGC
compatible unit in order to terminate the network.
• The EGC connection cable is available as an accessory
• Ensure the correct connection.(See Easy Garden Control System (EGC)).
1. Remove the protection cap from EGC-IN.
8
Tabla de contenido
