Gaggenau VL 414 110 Instrucciones De Instalación página 14

5 Secure the exhaust air pipe to the connecting
pieces and seal appropriately..
Note: If you use an aluminium pipe, smooth the
connection area beforehand.
14
6 Plug the control cable of the control unit into the
socket on the control desk. Connect the control
unit and the fan module with the control cable. All
plugs must snap into place. Connect the control
unit and fan module to the mains and check that
they work correctly. If the appliance does not
work, check that the connection cable is
positioned correctly.
7
Flush installation only: it is imperative to test
functioning before jointing!
gap with a suitable, temperature-resistant silicone
adhesive (such as OTTOSEAL
the seal joint with smoothing agent recommended
by the manufacturer. Observe the notes on
processing the silicone adhesive. Do not operate
the appliance until the silicone adhesive has dried
completely (at least 24 hours, depending on room
temperature).
NOTICE: Unsuitable silicone adhesive used on
natural stone worktops will cause permanent
discoloration.
Joint the surrounding
® S 70). Smoothen