Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
c) When battery pack is not in use, keep
it away from other metal objects like
paper clips, coins, keys, nails, screws,
or other small metal objects, that can
make a connection from one terminal to
another.
Shorting the battery terminals together may
cause burns or a fi re.
d) Under abusive conditions, liquid may
be ejected from the battery; avoid
contact. If contact accidentally occurs,
fl ush with water. If liquid contacts eyes,
additionally seek medical help.
Liquid ejected from the battery may cause
irritation or burns.
6) Service
a) Have your power tool serviced by a
qualifi ed
repair
identical replacement parts.
This will ensure that the safety of the power
tool is maintained.
SAFETY WARNINGS COMMON
FOR GRINDING OPERATIONS
a) This power tool is intended to function
as a grinder. Read all safety warnings,
instructions, illustrations and specifi cations
provided with this power tool.
Failure to follow all instructions listed below
may result in electric shock, fi re and/or serious
injury.
b) Operations
such
brushing, polishing or cutting-off are not
recommended to be performed with this
power tool.
Operations for which the power tool was not
designed may create a hazard and cause
personal injury.
c) Do not use accessories which are not
specifi cally designed and recommended
by the tool manufacturer.
Just because the accessory can be attached
to your power tool, it does not assure safe
operation.
d) The rated speed of the accessories must
be at least equal to the maximum speed
marked on the power tool.
Accessories running faster than their rated
speed can break and fl y apart.
4
person
using
only
as
sanding,
wire
e) The outside diameter and the thickness of
your accessory must be within the capacity
rating of your power tool.
Incorrectly
sized
adequately controlled.
f) The arbour size of wheels, sanding drums
or any other accessory must properly fi t
the spindle or collet of the power tool.
Accessories that do not match the mounting
hardware of the power tool will run out of
balance, vibrate excessively and may cause
loss of control.
g) Mandrel mounted wheels, sanding drums,
cutters or other accessories must be fully
inserted into the collet or chuck.
If the mandrel is insuffi ciently held and/or the
overhang of the wheel is too long, the mounted
wheel may become loose and be ejected at
high velocity.
h) Do not use a damaged accessory. Before
each use inspect the accessory such as
abrasive wheels for chips and cracks,
sanding drum for cracks, tear or excess
wear, wire brush for loose or cracked
wires. If power tool or accessory is
dropped, inspect for damage or install an
undamaged accessory. After inspecting
and
installing
yourself and bystanders away from the
plane of the rotating accessory and run the
power tool at maximum no-load speed for
one minute.
Damaged accessories will normally break
apart during this test time.
i)
Wear
personal
Depending
on
shield, safety goggles or safety glasses.
As appropriate, wear dust mask, hearing
protectors, gloves and workshop apron
capable of stopping small abrasive or
workpiece fragments.
The eye protection must be capable of stopping
fl ying debris generated by various operations.
The dust mask or respirator must be capable of
fi ltrating particles generated by your operation.
Prolonged exposure to high intensity noise may
cause hearing loss.
j)
Keep bystanders a safe distance away
from work area. Anyone entering the
work area must wear personal protective
equipment.
Fragments of workpiece or of a broken
accessory may fl y away and cause injury
beyond immediate area of operation.
accessories
cannot
an
accessory,
position
protective
equipment.
application,
use
be
face
Tabla de contenido
