TM
SCOUT
SJX SERIES BALANCES
3.10 Hold Mode
There are two modes for the display hold:
- Peak Hold: allows the user to capture and store the highest stable weight value (>=5d).
- Display Hold (default): allows the user to capture and store the first stable weight value (>=5d).
Start
If no weight value is held on the display, press Function key to begin. The [rEAdY] (Ready) will
be displayed until a weight is added on the pan.
When the stable value is being held on the display, the Hold icon (H) will blink and the displayed
weight will not change.
Reset
If the pan is empty and a weight value was held on the display, a single short press of the
Function key will clear the held value and show the new weight on the pan.
1. Press and hold Mode until [HoLd] is displayed.
2. If required, place an empty container on the pan and press Tare. Zero value will then
display.
3. Press Function key to begin. The [rEAdY] (Ready) will be displayed.
4. Place samples to be weighed on the pan.
5. The stable value will be held on the display, the Hold icon (H) will blink.
4. MENU SETTINGS
The User Menu allows the customizing of balance settings.
Note: Additional Sub-Menus may be available if Interface Options are installed. See Interface
User Manual for the additional setting information.
4.1 Menu Navigation
User Menu:
Sub-Menus
User Menu Items:
Long press -
Enter menu
Short press -
Yes
Accept
No/Back
Short press –
Go Next/Prev.
menu
Exit
Short press –
Exit menu
Note:
* These sub-menus are not available in SJX/E models.
** Available Units may vary by local regulations.
C.a.l
S.E.t.U.P
In.CAL*
Reset
A.CAL*
Filter
On/Off
Low/Med/High
CAL.Adj*
AZT
-100
0.5/1/3/Off
..
StableRange
0
0.5/1/2//5
..
100
Backlight
Span
Off/On/Auto
Auto Tare
Lin
Off/On/On-acc
Auto Off
Off/1/5/10
End
End
M.o.d.E
Reset
Yes/No
Yes/No
Weighing
On/Off
Counting
On/Off
Percent
On/Off
Check
On/Off
Totalize
On/Off
Density
On/Off
Hold
Disp/Peak/Off
End
U.n.i.t**
E.n.d
Reset
g
kg
ct
oz
ozt
dwt
lb
grn
hkt
sgt
twt
t
tola/tical
End
EN-9