Storage - Makita EN7350SH Manual De Empleo Y De Seguridad

STORAGE

WARNING: When draining the fuel, stop the engine and wait for the engine to cool down.
Failure to do so may cause burns or fire.
ATTENTION: When you store the machine for a long time, drain all fuel from the fuel tank and carburetor, and keep it at a dry and
clean place.
- Drain fuel from the fuel tank and carburetor according to the following procedure:
1) Remove the fuel tank cap, and drain fuel completely.
If there is any foreign materials remaining in the fuel tank, remove it completely.
2) Pull out the fuel filter from the refill port using a wire.
3) Push the primer pump until fuel is drained from there, and drain fuel coming into
the fuel tank.
4) Reset the filter to the fuel tank, and securely tighten the fuel tank cap.
5) Then, continue to operate the engine until it stops.
- Remove the spark plug, and drip several drops of engine oil through the spark
plug hole.
- Gently pull the starter handle so that engine oil will spread over the engine, and
attach the spark plug.
- Attach the cover to the cutting blades.
- During storage, keep the rod horizontal or keep the machine upright with the
blade edge oriented upward. (In this case, pay full attention to prevent the
machine from falling.)
- Never store the machine with the cutting blade edge oriented downward.
Lubricating oil may spill out.
- Keep the drained fuel in a special container in a well-ventilated shade.
Attention after long-time storage
- Before startup after long-time shutdown, be sure to replace oil (refer to P18). Oil will deteriorate while the machine is kept out of operation.
Operating
time
Item
Engine oil Inspect/clean
Replace
Tightening parts Inspect
(bolt, nut)
Fuel tank Clean/inspect
Drain fuel
Throttle lever Check function
Stop switch Check function
Cutting blades Inspect
Low-speed rotation Inspect/adjust
Air cleaner Clean
Ignition plug Inspect
Cooling air duct Clean/inspect
Fuel pipe Inspect
Replace
Gear-case grease Refill
Fuel filter Clean/replace
Clearance between Adjust
air intake valve
and air discharge
valve
Engine overhaul
Carburetor Drain fuel
*1 Perform initial replacement after 20h operation.
*2 For the 200 operating hour inspection, request Authorized Service Agent or a machine shop.
*3 After emptying the fuel tank, continue to run the engine and drain fuel in the carburetor.
Before Daily
operation (10h)
21
Drain fuel
25h 50h 200h
*
1
*
2
*
2
*
2
Humidity
Shutdown/ Corresponding
rest P
10
18
20
-
*
3
21
12
12, 14
12, 16
14
19
20
20
20
-
17
20
-
-
* 3
21