Bulb Replacement - Heath Zenith 4270 Instrucciones De Instalación Y Operación

MODE SWITCHING SUMMARY
TEST
AUTO
MANUAL MODE
* If you get confused while switching modes, turn
the power off for one minute, then back on. After
the calibration time the control will be in the AUTO
mode.
D B ® Dimmer Control
ual rite
Light comes on half bright for selected time after
dusk (Off, 3 hr., 6 hr., until dawn). Selecting OFF
disables this feature. The motion sensing features
will continue to work as described in this manual.
If motion is sensed, the light turns on full bright
for the ON-TIME (1, 5, or 10 minutes) then
returns to dim mode.
ADJUSTMENT OF COVERAGE AREA
The sensor on this light fixture detects "motion"
by the movement of heat across the coverage
area. However, following are examples of objects
that also produce heat and can cause the sensor
to trigger:
• Pools of Water
• Dryer Vents
• Heating Vents
If you suspect that a heat source of this type is
triggering the sensor, reduce the sensitivity.
205072-02
ON-TIME Switch at 1, 5,
or 10 minutes
Flip light switch
off for one second
then back on*
• Air Conditioners
• Animals
• Automobile Traffic

BULB REPLACEMENT

1. Remove decorative screw on rear of fixture
cap.
2. Lift cap up to remove.
3. Replace bulb.
4. Replace cap onto fixture.
5. Secure with decorative screw.
Fixture Cap
Remove Fixture Cap
7
Decorative Screw