Electric Brake - Makita DUH501 Manual De Instrucciones

► 1 . Reverse button
NOTE: If the entangled branches or debris cannot be
removed, release and pull the switch trigger until they
are removed.
NOTE: If you tap the reverse button while the shear
blades are still moving, the tool comes to stop and to
be ready for reverse movement.

Electric brake

This tool is equipped with an electric brake. If the tool
consistently fails to quickly stop after the switch trigger
is released, have the tool serviced at a Makita service
center.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
When replacing the shear blades,
always wear gloves so that your hands do not
directly contact the blades.
NOTICE:
When replacing the shear blades, do
not wipe off grease from the gear and crank.
Installing or removing the shear
blades
CAUTION:
Attach the blade cover before
removing or installing the shear blades.
You can install 500 mm (19-3/4"), 600 mm (23-5/8"), or
750 mm (29-1/2") shear blades to your tool.
1. Place the tool upside down, and then remove 6
screws.
1
► 1 . Screw
2. Remove the cover and the plate.
► 1 . Cover 2. Plate
NOTE: The plate may remain on the cover.
3. Remove the rod.
► 1 . Rod
NOTE: The rod may remain on the cover.
9 ENGLISH
1
1
2
1