Clatronic BS 1232 Instrucciones De Servicio página 36

5....-05-BS 1232
Winding
GB
Press the cable (5) winding button and guide the cable. Hold the cable to avoid wrap-
ping.
Nozzle Attachment:
The nozzle attachment is located below the take-up device for the mains lead or
below the outlet filter.
Crevice nozzle/Brush nozzle: For vacuuming upholstery, curtains and in corners
Floor nozzle:
Releasing the nozzles:
Dust bag replacement display (6):
Hold the hose up into air. If the dust bag change display lights up, the bag is full.
Please change it.
Changing the dust bag
Pull the plug out of the socket. Open the lid of the dust bag compartment by the
handle (9). Remove the dust bag holder and pull the dust bag out of the holder.
Insert a new dust bag. Reinsert the dust bag holder. Close the cover so that it
snaps into place.
Filter: Your appliance has two filters.
Motor protection filter (inlet filter):
The inlet filter is located in the dust bag compartment. The filter is located vertically
in the rear section of the dust housing. Remove the filter by pulling upwards. Clean
the engine protection filter after 10 dust bag changes. If necessary, the filter can
also be washed in warm water without any additives. Place it back into place only
once it is completely dry!
36
19.02.2003 8:09 Uhr
and crevices etc.
"2-in-1" nozzle: When this is folded together (as sto-
red in the compartment) it can be used as a groove
nozzle. If you would like to use the brush nozzle, pull
the brush section in the direction of the arrow until it
locks in place.
To clean carpets or smooth surfaces.
Smooth floors:
Press down the lever with the brush symbol with
your foot. The brush is now visible.
Carpets:
Press down the opposite lever.
Pull these off while turning slightly.
Seite 36