Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ChANGiNG ThE BLADE DRiVE ASSEMBLY
If your clipper blades no longer cut properly (be sure to try more than one blade, since blade
currently being used may be dull), it could be that your blade drive assembly needs replacement.
To change the blade drive assembly:
1. Remove blade set (Diagram L).
2. Remove drive cap (Diagram M).
3. Remove blade drive mounting screws (Diagram N).
4. NOTE: Before removing blade drive assembly, note the way it is positioned (this will help you in
reassembly). Remove blade drive assembly (Diagram O).
5. Drive bearing should be at its lowest position, if not, move it with
your finger to lowest position (Diagrams P & Q).
6. Put on new drive assembly, align screw holes and press down
(Diagram O).
7. Reassemble blade drive by replacing mounting screws, turning
just until snug (Diagram N). DO NOT OVERTiGhTEN.
8. Replace drive cap (Diagram M).
9. Replace blade (Diagram R).
Diagram M
Diagram P
FACTORY REpAiR SERViCE
When the blades of your Andis Clipper become dull after repeated use, it is advisable to send your
blades to an Andis Authorized Service Station mentioned below for resharpening. If you wish your
clipper to be serviced as well, they should be carefully packed and mailed either Parcel Post Insured,
or U.P.S.
8
Diagram N
Diagram Q
Diagram L
Diagram O
Diagram R
Tabla de contenido
