Garland DRILL 932 G Manual De Instrucciones página 38

English
Maintain your machine clean and in good conditions.
Clean the covers with a humid towel. Never use petrol
or other flammable products to clean the machine.
8.2. PERIODIC MAINTENANCE
Make periodic inspections of the machine to ensure
that the machine is correct.
For a thorough inspection take the machine to your
dealer.
Use only suitable spares to get a proper performance
for this machine. This replacement can be found on
the official distributor of the machine. Using other
sparks may causes risks, damage to the user or
people around the machine.
Carry out maintenance work based on the following
table:
Each 2
Operation petrol
deposits
Air filter •
Petrol filter
Spark plug
Cylinder fins
8.2.1. AIR FILTER
The dirt in air filter will cause a reduction in machine
performance.
Check and clean this element. If you notice damage or
alterations replace it with a new filter.
Each 10
Once a
petrol
year
deposits
•
•
•
38/132
To clean the filter:
1. Remove the protecting cover.
2. Remove the filter.
3. The dust accumulated on the outside of the filter
can be removed using your hands or against a
hard object.
4. Clean the filter with soapy water.
5. Rinse the filter with abundant water.
6. Allow the filter to dry.
7. Once dry, place two drops of oil (do not put too
much oil as otherwise the machine will not start).
8. Reinstall the air filter.
9. Replace the protecting cover.
Note: The engine should never started without the air
filter being in place.
8.2.2. FUEL FILTER
The fuel tank is equipped with a filter. It is at the end
of the suction pipe and can be removed with the help
of a hook of wire.
Check the fuel filter regularly. Do not allow dirty in the
fuel tank to prevent the filter is dirty. A dirty filter will
make it more difficult to start the engine and cause
malfunctions or stop it.
Check fuel. If you see dirty replace.
If the inside of the fuel tank is dirty you can clean it
with gasoline.
8.2.3. CHECK THE SPARK
The most common problems when starting a machine
are produced by a dirty spark plug or bad. Clean spark
plug and check it regularly. Check the electrode gap is
correct (0,6 - 0,7 mm).