Urrea SCT907 Manual De Usuario Y Garantía página 21

the blade is in motion, or kickback may occur.
Check and take corrective action to eliminate
the cause of blade binding.
3. Inspect the workpiece for knots or nails be-
fore cutting. Never saw into a knot or nail.
4. Do not cut warped or wet lumber.
5. Always support large panels to minimize the
risk of blade pinching and kickback.
Large panels tend to sag under their own
weight. Supports must be placed under the
panel: one near the line of cut and one near
the edge of the panel.
6. When restarting the saw in the workpiece,
center the blade in the kerf and check to be
sure that the saw teeth are not engaged into
the material. If the saw blade is binding, it may
walk up or kick back from the workpiece when
the saw is restarted.
7. Do not use a dull or damaged blade. Un-
sharpened, improperly set, or gummed-up
blades produce narrow kerfs, which cause ex-
cessive friction, blade binding, and Kickback.
8. Keep the blade at the correct depth setting.
The depth setting should not exceed 1/4 inch
below the material being cut. Be sure that the
blade depth and adjusting locking levers are
tight and secure before making a cut. If blade
adjustment shifts while cutting, it may cause
binding and Kickback.
Correct Blade
Depth
KICKBACK
9. Use extra caution when making a "Pocket
Cut" into existing walls or other blind areas.
The protruding blade may cut objects that can
cause Kickback.
STARTING / STOPPING THE SAW
To start the saw: Depress the trigger switch.
Always allow the blade to reach full speed, and
then guide the saw into the workpiece.
To stop the saw: Release the trigger switch.
After you release the trigger switch, allow the
blade to come to a complete stop.
Do not remove the saw from the workpiece
while the blade is moving.
MAKING DEPTH-OF-CUT ADJUSTMENTS
Always use the correct blade-depth setting.
The correct blade-depth setting for all cuts
should not be more than 1/4-inch deeper than
the material being cut. Increased cutting depth
will increase the chance of kickback and cause
the cut to be rough. Your saw is equipped with
a depth-of-cut scale that provides increased
depth-of-cut accuracy. The depth-of-cut scale is
located on the right side of the bracket.
1.Depth-of-cut
adjustment
lever
2. Depth-ofcut
scale
TO SET THE BLADE DEPTH
making any adjustments. Failure to unplug the
saw could result in accidental starting, which
can cause serious personal injury.
1. Unplug the saw.
2. Raise the depth-of-cut adjustment lever to
loosen the base.
3. Determine the desired depth of cut.
4. Locate the depth-of-cut scale on the right
side of the bracket.
5. Hold the base of the saw flat against the
edge of the workpiece, and then raise or lower
the saw until the indicator aligns with the de-
sired depth-of-cut mark.
6. Tighten the depth-of-cut adjustment lever.
Blade is Set
Too Deep
STARTING A CUT
port the workpiece. Always maintain proper
control of the saw. Failure to clamp and sup-
port the workpiece and loss of control of the
saw could result in serious injury.
of the saw to make sawing safer and easier.
Loss of control of the saw could cause an ac-
cident resulting in possibly serious injury.
1. Always use your saw with your hands posi-
tioned correctly:
E N G L I S H •
Blade is Set
1
Too Deep
WARNING: Always unplug the saw before
WARNING: Always securely clamp and sup-
WARNING: Always maintain proper control
U se r's m a n ua l
2
21