Hilti TE 60-A36 Manual De Instruccion página 21

▶ Check the tool and batteries for damage before use after long periods of
storage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
8.1 Troubleshooting
Trouble or fault
No hammering ac-
tion.
The battery runs
down more quickly
than usual.
The battery does
not engage with
an audible "double
click".
The drive spindle
does not rotate.
Product switches off
automatically.
*2201899*
Possible cause
The product is too cold.
Battery condition is not
optimal.
The retaining lugs on the
battery are dirty.
The permissible operat-
ing temperature of the
product's electronics
has been exceeded.
The battery is
discharged.
The overload protection
system is active.
2201899
Action to be taken
▶ Bring the product
into contact with
the working surface,
switch it on and allow
it to idle. If necessary,
repeat the procedure
until the hammering
mechanism begins to
operate.
▶ Replace the battery.
▶ Clean the retaining
lugs and refit the
battery.
The ON/OFF indicator
flashes.
▶ Allow the product to
cool down.
▶ Change the battery
and charge the empty
battery.
The ON/OFF indicator
flashes.
▶ Release the control
switch. Allow the
product to cool down.
Press the control
switch again. Reduce
the load on the tool.
English 15