RIB PRESIDENT PED Manual Del Usuario página 29

J18
J17
Power supply 230 Vac 50/60 Hz - external to the control panel -
J1 N F
(120 V 60 Hz upon request)
SECONDARY
J2 Connectors for secondary 18 Vac transformer
TRANSFORMER
BATTERY CHARGER Connector for 24V battery charger board (code ACG4774
J3
(24 V DC SOLAR optional)
J4 MOTOR Connector for 24 Vdc motor and 5 Vdc encoder
Connector for flasher 24Vdc (cod. ACG7061)
J5
Pay attention to the polarity.
A+ COM + 24Vdc accessories power supply
J6 A- - 24Vdc accessories power supply
A+TEST + 24Vdc photocells self-test power supply
R-AUX Auxiliary relay contact (NO) Max 700 W
Barrier opened warning light, operating signal with battery and
J7 SIGNAL
low battery (24Vdc 3W max)
COM A+ Contacts common / Positive 24 Vdc
PHOTO 1 Photocells contact 1 (NC)
PHOTO 2 Photocells contact 2 (NC)
J8 STOP STOP impulse contact (NC)
TLC Magnetic sensor contact for traffic light control in PARK mode
COM A+ Common contacts / Positive 24 Vdc
Connector for manual release switch
J9 SECURITY LOCK
(factory connected - DO NOT REMOVE!)
J1
J2
F1
J3 J4
J16 J15
F
N
J5 J6
J14
OPEN 1
OPEN 2
CLOSE
J10 START
B.I.O.
OK CLOSE
COM A+
J11
J12 APP+
J13 APP
J14 SERIAL COM /SYNC Connector for serial connection
J15 RADIO
J16 RADIO
J17
J18 AUX CARD
RUN
TCA
LOW SP.OP.
LOW SP.CL.
PROG
F1 T 2 A
F2 F10 A
29
J7 J8
J12 J13
Opening impulse contact (NO) - to enter
Opening impulse contact (NO) - to exit
Closing impulse contact (NO)
Single pulse contact (NO)
Contact (NO) dedicated to a timer
Contact for closing confirmation in PARK mode
Common contacts / Positive 24 Vdc
RS485 termination of J12
Connector for APP+ card
Connector for APP card
Connector for radio receiver RIB, 24 Vdc supply
Connector for radio module ACG8069
433 MHz Radio antenna
Card 1 relay connector (code ACQ9080) for management of
courtesy light.
Card 3 relay connector (code ACQ9081) for management of
courtesy light or traffic lights.
Trimmer for high speed adjustment operations Trimmer for automatic closing time adjustment (DISABLED BY
FACTORY AND DL9 LED OFF)
Electronic regulator for low speed on approach in opening
Electronic regulator for low speed on approach in closure
Programming button
Transformer protection fuse (external to the card P1 24V)
Fuse for motor protection
G
B
J9
J10
J11