Cleaning Or Replacement Of The Product Filter - Sagola 4100xtreme Serie Manual De Instrucciones

Gun head packing gland: In order to replace the packing gland, remove the product regulator and
extract the product needle and spring fitted with its stop. With a 13 mm fixed wrench, remove the
packing gland to be replaced. Replace the packing gland and reassemble in the reverse order.
Packing gland of the air valve: In order to replace the packing gland, remove the product regulator
and extract the product needle and spring fitted with its stop. With a 9 mm Allen wrench, remove
the guide box, extracting the valve spring, the valve and the bushing support. With a 6 mm Allen
wrench, remove the packing gland and extract the gasket. Replace the packing gland and the
washing support gasket (supplied in the specific kit) and follow the reverse procedure.

11.2. Cleaning or replacement of the product filter

· Gravity/suction version :
If there is any cleaning liquid or product remaining in the tank, return it to its corresponding
containers. To avoid any spillage, keep the pistol in a vertical position and clean as thoroughly as
possible.
Holding the pistol firmly by the handle, disassemble the tank by unscrewing it from the body of
the pistol.
Extract the product filter and if there is any cleaning liquid or product remaining in the body of the
pistol, return it to its corresponding container.
Clean or replace the product filter as needed, taking into account that the impurities will cause
defects in the finish and/or obstructions.
Assemble the product filter again, inserting it all the way into the hole in the input connector.
Fit the tank by screwing it firmly onto the body of the pistol, to avoid product leaks.
Tighten the filler cap firmly.
In the version with the non-drip cap, tip it forward (paint up) or back (paint down) as necessary.
Check there are no leaks.
· Pressure version:
Holding the pistol firmly by the handle, disassemble the
racord to the product inlet and extract the product filter.
Clean or replace the product filter as needed, taking into
account that the impurities will cause defects in the finish
and/or obstructions.
Assemble the product filter again, inserting it all the way
into the hole in the input connector.
ENGLISH
Product
filter
Code
56418057