Tig Process Instalation - Furius FIRE 215 Manual De Instrucciones

TIG PROCESS
12.
12.1 TIG PROCESS INSTALLATION
1. Turn on the machine
2. Select the current according to the filler diameter to be melted.
3. TIG torch cable connection: it must be connected in the socket with negative polarity and the work
clamp in the socket with positive polarity.
12.2 GAS
12.3 SCRATCHED TIG IGNITION
1. PLACE THE TORCH IN POSITION
2. SCRATCH THE TUNGSTEN
AGAINST THE WORKPIECE
Argon gas from a cylinder with a
flow regulator must be used for
this gas. The torch must be
connected directly to
regulator. The equipment does
not have a solenoid valve to
control the gas flow, so the use of
a torch with a knob
recommended for regulation and
interruption of gas flow.
It is recommended to adjust a gas
flow of 10 to 20 l / m or 21 to 40
CFH.
The arc start mode in TIG is scratch
TIG, which means that to start the
arc it is necessary to scratch the
tungsten against the workpiece.
3. SEPARATE THE TUNGSTEN
FROM 2 TO 4 MM TO START THE
ARC
the
is
20