Operation; Cleaning, Care & Maintenance; Troubleshooting - Polar CB920 Manual De Instrucciones

UK

Operation

Note: Before using for the first time (or after a period of inactivity), clean the water tank,
ice basket and ice basket shelf. Use the first two ice making cycles to flush out the
system. Discard the water and ice created from these initial cycles.
Press the Power switch (located on the front of the appliance) to the On position [I]. The initial cycle
1.
will take approximately 30 minutes, with subsequent cycles taking approximately 25 minutes.
When the cubes reach the ice sensor ice production stops. Production resumes once ice has been
2.
removed from the bin.
Press the Power switch to the Off position [O] at any time to halt the ice making process.
3.
Cleaning, Care & Maintenance
• Always switch off and disconnect the power supply before cleaning.
• Warm, soapy water is recommended for cleaning. Cleaning agents may leave harmful residues. DO
NOT wash the base unit, instead wipe the exterior with a damp cloth.
• Periodically remove the curtain, tray and nozzles and rinse in warm soapy water.
• A POLAR agent or qualified technician should carry out repairs if required.
• Clean the water filter regularly with a small brush, particularly in hard water areas.
The water filter is located just inside the water inlet at the back of the appliance.
• If the Ice Maker is to be left unused for longer than 24 hours, loosen the drain screw and drain the
water from the tank.

Troubleshooting

Fault
The appliance is
not working
Appliance is noisy
or works
intermittently
Compressor runs
but no ice is made
3
Probable Cause
The appliance is not switched
on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Ambient temperature below
10°C
Water supply
Bin is full
Power fluctuations
Refrigerant leak or block in the
refrigerant system
Bin is full
Action
Check the appliance is plugged in correctly and
switched on
Call POLAR agent or qualified technician
Replace the plug fuse
Check power supply
Call POLAR agent or qualified technician
Move appliance to a warmer position
Check water supply is on and supply hoses are
not blocked
Empty bin
Turn off the ice maker and restart after 3 minutes
Call POLAR agent or qualified technician
Empty bin