Replacing The Battery - Ferroli LATINA Manual De Instalación, Uso Y Mantenimiento

4.2.5

Replacing the battery

The remote control is powered by three batteries located in the back of the device. For insertion and possible
replacement, proceed as follows:
- Open the cover on the back of the remote control;
- Replace the AAA 1.5 V batteries, respecting the
polarity;
- Close the remote control
- Keep the remote control away from direct heat sources and water.
- The battery of the remote control must be replaced and disposed of in a safe way,
respecting the local regulations;
4.3 Use via control panel
To access the panel, remove the protection profile in the bottom of the stove .
Press button P3 on the control panel for a few seconds to turn the stove on and off. Use buttons P1 and P2 to set
the maximum power, indicated by the LED of button P2. Then the medium power equal to power 3, indicated by
lighting up of the LED of buttons P1 and P2, and lastly the minimum power, indicated by the LED of button P1.
It is not possible to set the temperature, the intermediate operating powers or access the various menus with the
emergency panel.
4.4 Optional probe and external thermostat
The standard unit controls the room temperature by means of a probe that adjusts the power according to the set
temperature. The probe is positioned in the remote control and measures the temperature in the place where the
remote control is located. The user can choose to use an external thermostat, connected directly to the
motherboard, whose sensor can be located in the most suitable place.
In case of an external thermostat, it is necessary to use a 'normally open' type. Contact an authorized technician
and follow the following instructions:
- turn the unit off at the main switch and disconnect the power cable;
-
remove the stove from the compartment and access the motherboard;
-
referring to the wiring diagram, connect the two thermostat wires to the respective terminals TERM of the board;
- refit everything, then set RADIO PROBE in menu 10;
- Then set as follows:

in case of external thermostat: Set a temperature of 7°C on the remote control and adjust the external
thermostat setting as desired;

in case of external chronothermostat: Set a temperature of 7°C on the remote control and adjust the
external chronothermostat setting as desired.
It is compulsory to disable the chrono function in menu 03 and set the STANDBY function to ON. When the
set temperature is reached, the stove will shut down and not go to modulation.
In any case, it is advisable to use the stove
chronothermostat setting function.This will avoid creating conflicts between the stove programming and
that of the chronothermostat
- Check correct operation.
In case of an optional probe, contact an authorized technician and proceed as follows:
-
turn the unit off by disconnecting the power cable or by using the external switch;
- remove the coating stove and access the motherboard;
- referring to the wiring diagram, connect the two wires of the probe to the respective terminals N.AMB of the
board and place the probe head in the position deemed most appropriate;
- refit everything and then set LOCAL PROBE in menu 10;
- check correct operation.
4.5 Idle period (end of season)
If the stove is not used for long periods, and/or at the end of each season, it is advisable to proceed as follows
- remove all the pellets from the hopper;
- disconnect the power supply by disconnecting the power cable or by using the external switch;
- clean thoroughly and, if necessary, have any damaged parts replaced by qualified personnel;
- in case of removal of the stove , arrange it in a safe and dry place, protected from the atmospheric agents.
Cover
time programming function and only the external
42 LATINA