Audemat Fm Probe Quick Start Notice - Worldcast Systems AUDEMAT FM PROBE Guía Rápida

English version
AUDEMAT FM PROBE
Quick start notice
1. Before you start
Make sure the following accessories are included in the box:
• 1 power cable
• 1 Ethernet cable
• 1 splitter (with 3 or more optional receivers)
• 1 quick start notice.
2. Starting the unit
Connect the power cord to the rear panel. The unit turns on automatically.
µSD board
2 Ethernet ports
3. Using the front panel application
Headset output
* Future use
Indicators:
• CPU LED: blinks to indicate CPU activity
• Critical/Major/Minor LEDs: On when a critical / major / minor alarm is on
The key pad on the right of the screen allows you to browse through the menus:
If the screen is in standby mode, press any key to reactivate it.
Arrows are used for scrolling
through menus, selecting
parameters and adjusting values.
LEDs indicate possible directions,
for instance, only up and down
arrows are available when
scrolling through main menus.
When adjusting values, press on
the top or down button for small
increments or swipe your fingers
around for large increments
4
USB Ports *
GPIO
RF2 + RF3 (optional additional receivers)
OLED screen
Analog and digital
audio outputs
RF inputs: RF1 (standard),
Navigation pad
Power
Ground
Status indicator
OTG port *
The Check button is used to:
• Access a lower level menu
• Enable the edit mode for
parameters that can be
modified,
• Confirm a new value.
The Return button is used
to
• Return to the higher level
screen,
• When in edit mode, go
back to the initial value.