DeWalt DWV009 Manual De Instrucciones página 31

4. Your D WALT construction dust extractor is fitted with the
E
D WALT AirLock connection system. The AirLock allows for
E
a fast, secure connection between the suction hose (G) and
power tool. The AirLock connector (N) connects directly to
D WALT compatable tools or through the use of an AirLock
E
adapter (available from your local D
Accessories section for detail on available adapters.
Note: If using an adapter ensure it is firmly attached to the tool
outlet before following the steps below.
a. Ensure the collar on the AirLock connector is in the unlock
position. (Refer to Figure 6.) Align notches (Q) on collar and
AirLock connector as shown for unlock and lock positions.
b. Push the AirLock connector onto the adapter connector
point.
c. Rotate the collar to the locked position.
NOTE: The ball bearings inside collar lock into slot and secure
the connection.The power tool is now securely connected to
the dust extractor.
5. Turn on the main on/off power switch (E).
NOTE: The tool outlet (L) is only energized when the vacuum is
turned on.
WET PICK UP APPLICATIONS (FIG. 1, 7)
WARNING: DO NOT connect power tools to outlet (L) when
using the vacuum for wet pick up.
WARNING: Plug vacuum into GFCI protected outlet when using
the vacuum for wet pick up.
NOTICE: DO NOT remove ball float (R), doing so will cause damage
to the vacuum. The ball float keeps water from entering the motor.
Before using the vacuum for wet pick up:
• Ensure the canister is empty and free of excessive dust.
• Remove filter (I).
• Plug vacuum into a GFCI protected outlet.
TO EMPTY CANISTER (FIG. 1, 7)
The ball float valve (R) will block air to
the motor when the canister is full and
the sound of the motor will change at
once. When the motor has a high pitched
WALT supplier). Refer to the
sound and air/water flow stops, empty the
E
canister.
TO CONVERT BACK TO DRY VACUUM OPERATION (FIG. 1)
To Shut Down (Fig. 1)
MAINTENANCE
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments or
accessories. An accidental start-up can cause injury.
29
1. Turn off vacuum and unplug cord from
outlet.
2. Unlatch canister latches (D) and remove
vacuum head (C).
3. Empty contents of canister (F) into a suitable container or drain.
1. Empty Canister, refer to To Empty Canister instructions.
2. Place canister upside down position until dry. DO NOT use wet
canister for dry pick up.
3. Place vacuum head (C) on a level surface until dry.
4. Reinstall filter when vacuum head is dry. See Filter under
Maintenance for details.
5. When canister is dry place the vacuum head (C) onto the
canister and secure it by closing the canister latches (D).
1. Turn off the main on/off power switch (E).
2. Unplug the unit.
WARNING: To reduce the risk of serious personal injury,
FIG. 7
R