Replace Interior Drum Light Bulb; Vacationing Precautions; Moving Or Storage Preparation - Haier GDE560BW Manual Para El Usuario

REPLACE INTERIOR DRUM LIGHT BULB

The interior drum light bulb can be replaced with a 15W or 30W, T7 Shape,
Intermediate (E17) Base, 120 volt appliance bulb.
1. Disconnect power, or unplug the dryer.
2. Open the dryer door. The light is located inside the drum above the door
opening.
3. Using a Phillips screwdriver, remove the screw from the Clear Light Cover.
Housing Tabs
Clear Light Cover
Screw
4. Remove the Clear Light Cover by rotating it forward and lifting it o of the two
Housing Tabs.
5. Turn the light bulb counterclockwise to unscrew.
6. Replace the bulb with a 15W or 30W, T7 Shape, Intermediate (E17) Base,
120 volt appliance bulb.
7. Replace the Clear Light Cover and secure it with the screw.
8. Reconnect power, or plug in the dryer.

VACATIONING PRECAUTIONS

•
Unplug the dryer from the electrical outlet or disconnect the power.
•
Wash the lint screen. See the "Washing the Lint Screen" section.
•
(For gas dryers only): Close shuto valve in gas supply line.

MOVING OR STORAGE PREPARATION

In addition to performing the steps in "Vacationing Precautions," complete the
following additional steps.
•
Disconnect the dryer from the exhaust system.
•
Turn the leveling feet so that they are fully retracted into the dryer cabinet.
•
Use masking tape to secure dryer door.
•
Move and store your dryer in an upright position only.
NOTE: For gas dryers, turn o the gas being supplied to the dryer. Disconnect the
dryer from the gas supply line and remove ttings attached to the dryer's gas inlet
pipe. Cap the gas supply line.
28
A
C
B