Pentair Intellibrite 5g white led Guia De Instalacion página 13

REPLACING THE INTELLIBRITE WHITE POOL LIGHT CIRCUIT BOARD
ASSEMBLY (IN AN EXISTING POOL) (Continued)
5. Place a cloth on the ground
to protect the lens. Turn
the light over so the lens is
resting on the cloth. Using a
¼" nut driver and a #3 Phillips
screwdriver, remove the nut
uni-tension wire clamp. Place
the nut aside for reinstallation.
6. Remove the face ring
and wire clamp from the
light housing.
7. With the light resting on
its base, carefully pry
off the gasket to remove
the lens. Set the lens
aside for installation later.
Discard the gasket.
Note: A NEW LENS
GASKET
(P/N 79101600Z)
MUST BE USED EACH
TIME THE LIGHT IS
REASSEMBLED.
Note: Note the current position of the lens at the pilot screw (12 o'clock)
position, before removing it from the fixture. "W" on the lens indicates wide
angle, "N" indicates narrow angle. For more information, see page 13.
8. Using a ¼" nut driver, carefully remove the four retainer nuts from the
light assembly (see illustration on next page). Place the nuts aside for
reinstallation.
9. Unplug the two connector plugs from the circuit board. Lift up the circuit
board and remove it from the light housing base.
10. Carefully lift off the old thermal strips from the base of the light housing base
and discard.
Continue on next page.
13 13
Gasket
Lens
uni-tension
wire clamp:
Remove nut
and screw
Face ring