Pentair Intellibrite 5g white led Guia De Instalacion página 5

IntelliBrite 5g White Pool and Spa Lights Overview
®
This manual describes how to install the IntelliBrite white 5g underwater pool ligh and the
white spa light. The IntelliBrite white lights provides brilliant white light for a spectacular
effect in your pool and spa.
Operating Pool and Spa Lights Using a Wall Switch (12 VAC)
The white pool and spa lights can be manually controlled using a standard wall-mount
light switch. Multiple IntelliBrite lights can be connected via a junction box to a single
switch so that all lights can be switched on and off together. IntelliBrite lights can also be
automatically controlled via Pentair IntelliPool® automation system.
Using an External Transformer for Multiple IntelliBrite 12 VAC Lights
When using multiple IntelliBrite 12 VAC LED lights on a 300 Watt transformer, it is
recommended that no more than three IntelliBrite pool lights and one (1) IntelliBrite Spa
light be used. It is also recommended not to exceed 30 meter of total cable run between
the transformer and light. Note: For long cable lengths, set transformer to 14 VAC (see
diagram below).
300 Watt
Transformer
300 Watt
Transformer
Troubleshooting
The light will not illuminate or does not function properly:
Check the GFCI ground fault wiring and reset if necessary.
Check the light wiring connection to the junction box at the pool side and to the AC power
switch.
Be sure that there is proper AC power applied to the light.
12 Gauge
J Box
(minimum)
45 m. max. for spa light
12 Gauge
J Box
(minimum)
60 m. max. for pool light
30 m.
5