Intended Use; Assembly And Adjustments; Installing And Removing The Battery Pack - DeWalt DCS570 Manual De Instrucciones

Intended Use

This heavy-duty circular saw is designed for professional
wood cutting applications. Do not cut metal, plastic,
concrete, masonry or fiber cement materials.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use this tool.

ASSEMBLY AND ADJUSTMENTS


WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.

WARNING: To reduce the risk of serious personal
injury, always wear ANSI compliant eye protection.
Assembling the Dust Port (Fig. D, E)
(Optional Accessory)
1. Fully loosen depth adjustment lever (
2. Align the dust port–back half
20
guard as shown. Be sure to insert the tab
the casting notch on the tool as shown in Figure E.
When installed correctly, it will snap fully over the
original depth of cut pointer.
22
3. Align the dust port with the dust port–back half
4. Insert two dust port screws
tighten securely.
Fig. D
4
19
23
4
, Fig. D).
19
over upper blade
21
into
19
.
23
as shown and
20
6
23
22
Fig. E
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.

Installing and Removing the Battery Pack

(Fig. F)
nOTE: For best results, make sure your battery pack is
fully charged.
3
To install the battery pack
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
13
button and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. F
English
21
21
into the tool handle, align the
13
3
9