Install The Mulch Plug; Set The Blade Height; Install The Battery Pack; Remove The Battery Pack - Powerworks P48LM41 Manual Del Operario

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
3. Hold the the grass catcher by its handle and put the
hooks over the slots.
4. Close the rear discharge door.
3.5

INSTALL THE MULCH PLUG

Figure 5.
1. Remove the grass catcher.
2. Open the rear discharge door and hold it.
3. Hold the mulch plug by its handle and fit it in the
discharge chute.
4. Close the rear discharge door.
3.6

SET THE BLADE HEIGHT

The machine can be set to different blade heights.
Figure 6.
1. Push the height adjustment button, move the height
adjust gear to a higher position to increase the blade
height.
2. Push the height adjustment button, move the height
adjust gear to a lower position to decrease the blade
height.
3.7

INSTALL THE BATTERY PACK

Figure 7.
WARNING
If the battery pack or charger is damaged, replace
the battery pack or the charger.
Stop the machine and wait until the engine stops
before you install or remove the battery pack.
Read, know, and follow the instructions in the
battery and charger manual.
1. Open the battery door.
2. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
3. Push the battery pack into the battery compartment
until the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.
NOTE
The engine starts only when you put in the safety key.
3.8

REMOVE THE BATTERY PACK

Figure 7.
1. Open the battery door.
2. Remove the safety key.
3. Push and hold the battery release button.
4. Remove the battery pack from the machine.
English
4

OPERATION

Wear eye protection during operation.
4.1

START THE MACHINE

Figure 8.
1. Put in the safety key.
2. Push and hold the start button.
3. While you hold the start button, pull the bail switch in
the direction of the handle bar.
4. Release the start button to start the machine.
4.2

STOP THE MACHINE

Figure 8.
1. Release the bail switch to stop the machine.
Wait until the blades fully stop before you start the
machine again. Do not quickly turn the machine off
and on.
Always remove the safety key and battery pack after
you complete the work.
4.3

EMPTY THE GRASS CATCHER

Figure 9.
1. Stop the machine.
2. Remove the safety key.
3. Remove the battery pack.
4. Open the rear discharge door and hold it.
5. Hold the grass catcher by its handle and unhook it
from the slots.
6. Close the rear discharge door.
7. Empty the grass catcher.
4.4

OPERATE ON SLOPES

Do not mow on the slopes with decline more than 15°.
If you are not comfortable, do not mow on a slope.
Please keep a low self-propelled speed when you
mow on a slope.
5
WARNING
WARNING
WARNING
WARNING
WARNING
EN
Tabla de contenido
loading

Tabla de contenido