Description; Purpose; Overview; Safety - Powerworks P24LM32 Manual Del Operario

EN
1

DESCRIPTION

1.1

PURPOSE

This machine is used for domestic lawn mowing. The
cutting blade must be approximately parallel to the
ground. All four wheels must touch the ground while you
mow.
1.2

OVERVIEW

Figure 1-7.
Switch box handle
1
Start button
2
Motor control cable
3
Upper handle
4
Lower handle
5
Front wheel
6
Rear wheel
7
Grass catcher
8
Knob
9
Nut
10
Grass catcher handle
11
Slot
12
Rear discharge door
13
Rear discharge opening
14
Battery door
15
Blade
16
Mounting screw
17
Spacer
18
Blade locating tube
19
Front axle
20
Rear axle
21
Battery pack
22
2

SAFETY

Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3

INSTALLATION

Do not change or make accessories that are not
recommended by the manufacturer.
Do not put in the safety key or the battery pack until
you assemble all the parts.
WARNING
WARNING
WARNING
English
3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine
before use.
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
3.2

INSTALL THE UPPER HANDLE

Figure 2.
1. Align the holes in the upper handle and the lower
handle.
2. Put the nuts through the holes.
3. Tighten the knobs onto the nuts.
4. Do the same operation on the other side.
3.3

INSTALL THE GRASS CATCHER

Figure 3
1. Put the four screws into the washers to attach the
bracket.
2. Move the bracket into the groove.
3. Align the latches and the slots of the top and lower
halves of the grass catcher and push the two halves
together to interlock.
4. Push the latch of the handle into the grass catcher.
5. Open the rear discharge door and hold it.
6. Hold the the grass catcher by its handle and put the
hooks over the slots.
7. Close the rear discharge door.
3.4

SET THE BLADE HEIGHT

The machine can be set to different blade heights.
Figure 4
1. Turn the machine over to access the front and rear
cutting height adjustment.
2. Push the axle forward to unlock the cutting height
adjustment.
4
WARNING
WARNING