Install The Grass Catcher; Install The Mulch Plug; Set The Blade Height; Install The Battery Pack - Powerworks PD60LM61SP Manual Del Operario

1. Align the holes in the upper handle and the lower
handle.
2. Put the bolts through the holes.
3. Tighten the knobs onto the bolts.
4. Do the same operation on the other side.
3.4

INSTALL THE GRASS CATCHER

Figure 4.
1. Remove the mulch plug.
2. Open the rear discharge door and hold it.
3. Hold the the grass catcher by its handle and put the
hooks over the slots.
4. Close the rear discharge door.
3.5

INSTALL THE MULCH PLUG

Figure 5.
1. Remove the grass catcher.
2. Open the rear discharge door and hold it.
3. Push the latches on each side of the mulch plug
handle and fit it in the discharge chute.
4. Attach the mulch plug in the discharge chute until
the tabs engage the holes behind the mower deck.
5. Close the rear discharge door.
3.6

SET THE BLADE HEIGHT

The machine can be set to different blade heights.
Figure 6.
1. Pull the height adjustment lever rearward to
increase the blade height.
2. Pull the height adjustment lever forward to decrease
the blade height.
3.7

INSTALL THE BATTERY PACK

Figure 7.
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the engine stops
before you install or remove the battery pack.
• Read, know, and follow the instructions in the
battery and charger manual.
1. Open the battery door.
2. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
3. Push the battery pack into the battery compartment
until the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.
English
The engine starts only when you put in the safety key.
3.8

REMOVE THE BATTERY PACK

Figure 7.
1. Remove the safety key.
2. Open the battery door.
3. Push and hold the battery release button.
4. Remove the battery pack from the machine.
4

OPERATION

Wear eye protection during operation.
4.1

START THE MACHINE

Figure 7 - 8.
1. Open the key cover.
2. Put in the safety key.
3. Push and hold the start button.
4. While you hold the start button, pull the bail switch in
the direction of the handle bar.
5. Release the start button to start the machine.
Soft-Start
This Li-ion machine has a "soft-start" feature.
When you start the machine, it goes to full speed after
approximately 3 seconds.
If the machine does not start, remove the battery pack
and examine the mower deck to make sure that:
• no grass catches on the blade.
• the blade can turn freely by hand.
4.2

STOP THE MACHINE

Figure 8.
1. Release the bail switch to stop the machine.
Wait until the blades fully stop before you start the
machine again. Do not quickly turn the machine off
and on.
Always remove the safety key and battery pack after
you complete the work.
5
NOTE
WARNING
NOTE
WARNING
WARNING
EN