Charging Tips; Maintenance And Care - Schumacher Electric SC-12000A Manual Del Propietário

Read this entire manual before using your charger. The tips below serve only as a guide
for specific situations.
If your vehicle won't start: You don't
need to fully charge a battery to start your
vehicle. If the charger won't start your
vehicle using the ENGINE START rate, try
charging the battery using the REGULAR
BATTERY rate for 10 or 15 minutes. That
should charge the battery enough to al-
low the ENGINE START rate to start the
vehicle. If the vehicle will then be operated
continuously for an extended period (such
as a long drive), the vehicle could charge
the battery back to normal during that
period. If the vehicle will only be operated
for a short period (short drive), the battery
might need to be charged again before it
could start the vehicle again.
A minimal amount of care can keep your battery charger working properly for years.
1. Clean the clamps each time you are finished charging. Wipe off any battery fluid
that may have come in contact with the clamps to prevent corrosion.
2. Coil the input and output cords neatly when storing the charger. This will help pre-
vent accidental damage to the cords and charger.
3. Occasional cleaning of the case of the charger with a soft cloth will keep the finish
shiny.

CHARGING TIPS

MAINTENANCE AND CARE

13
Reviving your battery: If you only wish
to charge your battery enough to operate
your vehicle, you don't need to wait for the
entire charging process to be completed.
When the charger displays a battery %
of 77 or more (see page 14), the battery
has usually been charged enough for the
vehicle to start and operate normally.
Completing an interrupted charge: If
the charging process has been interrupted
and restarted after the charger displays a
battery % of 85 or more, the charger could
go straight to Maintain Mode (see page 8).
However, if the original charge was started
using the REGULAR BATTERY rate, the
charge can often be completed using the
SMALL BATTERY setting.