Legs/Feet; The Handle Installing; Wine Shelves - CASO DESIGN WineComfort 380 Smart Instrucciones De Funcionamiento Originales

 Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.
 The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 15 cm around the appliance.
 WARNING! Do not close the ventilation openings in the device housing.
 The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
 The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they guarantee
the prerequisites for the safe use of this device.
 For energy saving reasons please ensure that the door is closed when the appliance is
turned on.
12.5.2

Legs/feet

There are FOOT (3 bigger feet and 1 small
foot).
To level your appliance, adjust the front legs
at the bottom of the appliance.
12.5.3

The handle installing

The wine cooler comes with one metal
stainless steel handle. To install simply screw
them to the door with the supplied screws.
To do this, slide the rubber seal on the back
of the door to the side to lay open the
predrilled holes. Use the included screws to
install the handle on the door.
Then reinsert the rubber seal in the correct
position.
12.5.4

Wine shelves

Usual shelf Lower shelf
33