Maintenance; General; Maintenance Schedule - Husqvarna PG 530 Manual De Instrucciones

General

WARNING! The user must only carry out the maintenance and service work described in this
!
Operator's Manual. More extensive work must be carried out by an authorized service workshop.
The machine should be switched off with the power cable disconnected from the outlet.
Wear personal protective equipment. See instructions under the "Personal protective equipment"
heading.
The life span of the machine can be reduced and the risk of accidents can increase if machine
maintenance is not carried out correctly and if service and/or repairs are not carried out
professionally. If you need further information please contact your nearest service workshop.
Let your Husqvarna dealer regularly check the machine and make essential adjustments and repairs.

Maintenance schedule

Item
Check that head locks are
tight.
Inspect heads for slop/
broken 'fingers" if using
spring steel heads.
Check effectiveness of
planetary seal.
Check condition of chain
ring.
Check condition of Drive
Sprocket.
Inspect internal
components of machine.
Clean contents of
electrical cabinet.
Prior to removing belt tensioner cover plate, ensure cover plate and area surrounding cover plate are totally clean.
Avoid debris from entering into inside of machine.
22 – English

MAINTENANCE

Action
Tighten head locks and re-set in thread-locking compound if required
(Suggested thread-locking compound Loctite 680).
Examine machine heads while machine tipped back. Disconnect
Planetary Drive motor (small motor) and run discs at lowest speed.
Check to see how concentric/true grinding heads are running.
Remove planetary head motor/gearbox system and check for presence
of dust under machine cover.
Remove planetary head motor/gearbox system and inspect chain links
in chain ring. Ensure links are clean and free from build-up.
Remove planetary head motor/gearbox system and inspect condition of
planetary drive sprocket.
Remove belt tensioner cover plate and check inside machine for dust,
moisture or belt fragments. Ensure to re-seal cover plate with silicone
sealant.
Blow out inside of electrical cabinet and variable speed drives or
frequency converters with DRY compressed air.
Frequency
Daily
Daily
Weekly
Weekly with
Planetary Seal
Weekly with
Planetary Seal
6 monthly
Every 2 months