Genesis GMDB1215LF Manual Del Operario página 6

Keep your hands out of the path of the saw blade
•
your hands to be within 7-1/4" of the saw blade, the workpiece should be clamped in place before making
the cut.
Keep the motor air slots clean and free of chips
•
impair the flow of cooling air to the motor.
Make sure all the saw's adjustment handles are tight
•
is positioned in one of positive stops. Do not forget to tighten the bevel adjustment handle.
Never apply lubricants
•
Never use saw blades
•
Never start the tool
•
Allow the motor to attain full speed
•
Always keep the blade guards in place
•
Never reach around
•
Never lock the switch
•
Never attempt to recut small pieces.
•
Never cut ferrous metals or masonry
•
products.
• Do not perform free-hand cutting operations
table. Use clamps to hold the work when possible.
• Long or wide workpieces should be properly supported.
IMPOrTANT: After completing the cut
•
come to a complete stop before returning the saw to a raised position.
Turn off the saw and allow the blade to completely stop
•
area or removing debris and off-cuts in the path of the blade. Coasting blades are dangerous.
Turn off the saw and allow the blade to completely stop
•
securing the workpiece, changing the workpiece angle, or changing the angle of the blade.
Never perform layout,
•
running.
Turn the machine "off" and disconnect the machine
•
installing or removing accessories, before adjusting or changing set-ups, or when making repairs.
Disconnect the machine
•
machine.
If any part of your miter saw is missing, damaged, or fails in any way,
•
electrical component fails to perform properly, shut off the switch and remove the plug from the power
source. Replace missing, damaged, or failed parts before resuming operation.
WArNINg:
instructions before using this equipment. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious personal injury.
6
to the blade when it is running.
rated for operation at less than 5000 RPM.
with the workpiece against the blade.
or behind the saw blade.
in the "ON" position.
assembly or set-up work on the saw table or work area while the machine is
from the power source and clean the work area before leaving the
read and understand all warnings, cautions and operating
SAVE THESE INSTRUCTIONS
12" Dual-Bevel Sliding Compound Miter Saw
Operator's Manual
. If the workpiece being cut causes
, dust, or other obstructions which may
before cutting, even if the table
prior to starting the cut.
and use at all times.
. This miter saw is designed to cut wood and wood-like
. Hold the work firmly against the fence and
, release the power switch and allow the blade to
from the power source before
GMSDB1215LF
before cleaning the blade
before removing or un-
or any