Maintenance; Technical Data - Urrea TB912 Manual De Usuario

• Use the drilling setting initially then revert
to the hammer action once the holes are es-
tablished.
• Apply light pressure and medium speed for
best results in brick.
• Apply additional pressure and high speed for
hard materials such as concrete.
NOTE: When drilling holes in tile, practice on
a scrap piece to determine the best speed and
pressure.
NOTE: reverse rotation during impact drilling
may damage the drill and drill bit.

MAINTENANCE

WARNING: Always ensure that the plug is
disconnected from power source, the tool is
switched off and the battery pack is removed
before making any adjustments or mainte-
nance procedures the cordless drill and charger.
· Regularly check that all the fixing screws are
tight. They may vibrate loose over time.
Keep the tool's air vents unclogged and clean
at all times.
· Regularly check to see if any dust or foreign
matter has entered the vents near the motor
and around the switches.
Use a soft brush to remove any accumulated
dust. Wear safety glasses to protect your eyes
whilst cleaning.
If the body of the tool needs cleaning, wipe
it with a soft damp cloth. A mild detergent
can be used but nothing like alcohol, petrol or
other cleaning agent.
CAUTION: Water must never come into con-
tact with the tool.
DISPOSAL OF AN EXHAUSTED BATTERY PACK
To preserve natural resources, please recycle or
dispose of the battery pack properly.
This battery pack contains Li-ion batteries.
Consult your local waste authority for informa-
tion regarding available recycling and/or dis-
posal options.
Discharge your battery pack by operating your
tool, then remove the battery pack from the
tool and cover the battery pack terminals with
heavy duty adhesive tape to prevent short cir-
cuit.
IMPORTANT: Do not attempt to open or
remove any of the components.
E N G L I S H •

TECHNICAL DATA

BATTERY
CHARGER INPUT
CHARGER OUTPUT
SPEED
CHUCK CAPACITY
TORQUE
TORQUE POSITIONS
WEIGHT
U se r's m a n ua l
12 V
120 V ~ 60 Hz
12 V 1,5 A
High: (0 - 1 500) r/min
Low: (0 - 400) r/min
3/8" (10 mm)
20 Nm
18
1 kg (2,2 lb)
17